Overview
The Oracle Lighting ORC5882-504 is a set of flush mount LED tail lights for the 2020–2026 Jeep Gladiator (JT). They are a low-profile replacement for the factory tail lights, designed to sit flush with the truck bed while adding LED reverse lighting and signature perimeter lighting. They are a direct fit for the Gladiator trims covered below.
Because the lights wrap tightly around the bed, they protrude significantly less than the factory units, which Oracle says helps avoid damage on trail rides. The wrap-around shape keeps the lights visible from most rear angles. Owners of Gladiators with the optional cross-traffic sensor will find the design accommodates it, and the sensor can be moved over from the factory assembly.
Key features
- Flush-mount, wrap-around design that protrudes less than factory tail lights
- Reverse light with 10 high-powered LEDs for rear illumination
- Signature perimeter lighting
- Enhanced reverse function
- Accommodates the optional cross-traffic sensor, which can be swapped over from the factory assembly
- Plug-and-play design, compatible with base and LED packages
Preparing the rear wiring
Flush mount tail lights change how the rear of the truck is wired, so planning the work helps. Disconnect the battery before touching any rear connector, and label the factory plugs before separating them. Keep the cross-traffic sensor connector sealed while you move parts, since moisture at that plug can cause a fault.
Reverse lamp issues on halogen-equipped trucks are the most common concern after an LED swap. Check the reverse function after a long drive, and confirm the wiring is seated before testing. Keeping the plugs clean and the grounds tight helps the new lights work consistently over time.
- Disconnect the battery first
- Label factory connectors before removal
- Test reverse lights after extended use
- Seal and secure connectors after testing
Specifications
| Brand | Oracle Lighting |
|---|---|
| Part number | ORC5882-504 |
| Product type | Flush mount LED tail lights |
| Reverse light | 10 high-powered LEDs |
| Wiring | Plug-and-play |
| Compatibility | Base and LED packages |
| Fitment type | Direct fit |
Vehicle fitment
Oracle Lighting lists these tail lights as a direct fit for the 2020–2026 Jeep Gladiator (JT). Covered trims are 80th Anniversary, Altitude, High Altitude, Launch Edition, Mojave, Overland, Rubicon, Sport, Sport S, Willys and Willys Sport.
Gladiator trims outside that list, and other Jeep models such as the Wrangler, are not covered by this fitment. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The lights are plug-and-play, and the cross-traffic sensor can be moved from the factory assembly into these tail lights. Factory halogen equipped Jeeps may need a small resistor added if the reverse lights shut off after extended use, or a programmer such as a J-scan or Tazer can correct it. Disconnect the battery before working on rear wiring.
What’s included
The product is a set of flush-mount LED tail lights for the Gladiator.
Not included: Confirm the package contents before ordering, so you know what hardware you will need.























