Overview
The Omix-ADA 17467.01 is a set of standard size connecting rod bearings for the 4 cylinder 134 engine. It comes as a pair.
The manufacturer fitment list is long and covers Willys and Jeep models from 1941 to 1971, including the CJ3, CJ5, CJ6, DJ, FC, Jeepster and Utility lines.
Key features
- Standard size bearing.
- Sold as a pair for the 4 cylinder 134 engine.
- Covers the Willys and early Jeep models listed below.
- Omix-ADA part number OAI17467.01.
Before you buy
Connecting rod bearings are thin shells that ride on the crankpin and carry the load of each rod as the engine turns. Over time they wear, scratch or pick up debris, and a worn shell can lead to knocking and low oil pressure. Replacing them is usually part of a larger engine overhaul, when the crankshaft journals can be checked for taper and out-of-round before new shells go in.
Matching the bearing to the crank matters. Standard size fits journals that have not been ground, so measure each journal with a micrometer and compare it against the bearing size. If a journal is worn past the limits in your service manual, it may need regrinding and an undersize bearing instead.
- Check crank journals for scoring before installing
- Verify rod and cap numbers match
- Use fresh engine oil on bearing surfaces
- Replace rod bolts that show stretch
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | OAI17467.01 |
| Part type | Connecting rod bearings |
| Engine application | 4 cylinder 134 engine |
| Size | Standard |
| Quantity | Pair |
| Fitment | Direct fit, per manufacturer |
Vehicle fitment
The manufacturer fitment list includes the 1959–1960 and 1968–1971 CJ5 and CJ6, 1959–1960 CJ3, 1967–1971 DJ5, 1967 Commando, 1961–1967 Dispatcher, 1958–1966 FC150, 1964–1966 FC170, 1967–1971 Jeepster, and Willys models from 1941 to 1955.
CJ5 models from 1972 onward and other later Jeep models fall outside the covered years. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Connecting rod bearings are installed during engine disassembly, so the rods and crankshaft are normally inspected and measured before new bearings go in.
What’s included
The set is connecting rod bearings only. Check the package contents against your installation before starting.











