Overview
The Omix-Ada OAI17410.01 is a push rod for 2.5L 4-cylinder engines. It fits Jeep Cherokee XJ, Wrangler YJ and TJ, CJ5 and CJ7, Comanche, Scrambler and Wagoneer SJ models from 1983 to 2002.
A push rod carries lifter motion up to the rocker arm, which opens and closes the valve. Because fitment is tied to model and year, match the rod to your engine and vehicle before installing it.
Key features
- Push rod for 2.5L 4-cylinder engines
- Direct fit for the Jeep models covered below
- Made to original specifications by Omix-Ada
- Limited 5-year manufacturer warranty
Valve train checks
A push rod transfers lifter movement up to the rocker arm, so any bend or wear at the ends changes valve timing and lift. Worn ends can have flat spots or pitting where they sit in the lifter and rocker socket. A rod that is slightly bent may cause a ticking sound or uneven idle, especially after the engine has been running hard.
When inspecting push rods, roll them on a flat surface and look for a wobble, then check the ends under good light. Replace any rod with a bend, a worn tip or a pitted socket surface, and inspect the lifters and rocker arms at the same time. Keep the rods in their original order so each one returns to its cylinder.
- Roll rods on a flat surface to check for bends
- Inspect rod ends for flat spots or pitting
- Keep rods in cylinder order during removal
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | OAI17410.01 |
| Engine | 2.5L 4-cylinder |
| Component | Push rod |
| Warranty | Limited 5-year manufacturer warranty |
Vehicle fitment
Omix-Ada’s list covers 1983 CJ5, 1983–1986 CJ7, 1983–1985 Scrambler, 1987 Wagoneer SJ, 1987–1992 Comanche, 1987–2000 Cherokee XJ, 1987–1995 Wrangler YJ and 1997–2002 Wrangler TJ, with trims shown for each model.
Models not on this list, such as Wrangler JK and Cherokee KJ, are not covered. Confirm your vehicle’s year, model and trim before ordering.
What’s included
One push rod.
Not included: rocker arms, pivots and lifters, which are separate parts.









