Overview
The Omix-Ada OAI17427.01 is a standard-size piston with its pin fitted, so the piston and pin come as one part. It fits 134 4-cylinder engines. It fits Jeep CJ, DJ, FC and Jeepster models and several Willys vehicles built from 1941 to 1971.
Standard size means the piston is not an oversize unit, so it suits a bore that has not been machined larger. No diameter or pin type is given, so measure the bore and check the pin specifications before assembly.
Key features
- Standard size
- Piston supplied with its pin
- For 134 4-cylinder engines
- Made to original specifications, with a limited 5-year manufacturer warranty
Choosing a replacement piston
When a piston is replaced, the rest of the bottom end is usually inspected at the same time. Rod bearings, crankshaft journals and cylinder walls all affect how a new piston seats and seals, so measuring the bore for taper and out-of-round wear is a sensible first step before fitting new parts.
Piston rings are normally replaced with the piston, since old rings rarely seal well against new surfaces. Check ring end gap in the bore before fitting the rings, and make sure the ring grooves are clean. A loose pin fit can cause noise and early failure, so the pin and rod should be inspected as well.
- Measure bore taper and out-of-round wear
- Replace rings together with the piston
- Check ring end gap in the bore
- Inspect rod bearings and crankshaft journals
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | OAI17427.01 |
| Engine | 134 4-cylinder |
| Size | Standard |
| Included | Piston with pin |
| Warranty | Limited 5-year manufacturer warranty |
Vehicle fitment
It fits 1959–1960 and 1968–1971 CJ5 and CJ6, 1967–1971 DJ5 and Jeepster, 1956–1958 Willys CJ-5, CJ-6 and DJ-3, and other Willys and Jeep models from 1941 to 1971. Confirm fit for your vehicle’s year, model and trim before ordering.
Later Jeep models, including Wrangler and Cherokee built after 1971, are not covered by this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Measure the bore and confirm the pin fit to the rod before assembly, and check piston-to-bore clearance against the engine rebuild requirements. Handle the piston and rings carefully to avoid damage.
What’s included
One piston with its pin.
Not included: piston rings, connecting rods and bearings, which are separate parts for this engine.









