Overview
The Omix-Ada 17215.04 is an electric oil pressure gauge for in-dash mounting on the Jeep CJ5, CJ7 and Scrambler. It fits the 1976–1983 CJ5, 1976–1986 CJ7 and 1981–1985 Scrambler.
The gauge is 2-1/16 inch in diameter, sits in Omix-Ada’s Factory Match Jeep series, and has a black face with standard units. It is a direct replacement for the oil pressure reading on those dashes.
Key features
- Electric oil pressure reading on the dash
- Factory Match Jeep series styling
- 2-1/16 inch diameter for in-dash mounting
- Black face, standard units
Sender and wiring basics
An oil pressure gauge reads a sending unit threaded into the engine, and that sender sends a varying signal to the dash. Because the gauge depends on the sender, a bad sender can look like low oil pressure when the engine is fine. Check the sender’s threads and sealant before installing it, and watch for oil weeping from the fitting once the engine warms.
On older CJ and Scrambler wiring, insulation often cracks where harnesses pass through the firewall. Inspect the wire routing before reconnecting, and keep the harness clear of the exhaust, the steering column and moving linkage. Use a fresh ground point if the gauge needle wanders at idle.
A mechanical test gauge is the usual way to confirm readings. Connect it at the sender port during a warm idle check, and compare the results with what the dash gauge shows before trusting either one on the road. Recheck the reading after the first few drives, since loose connections often show up once the engine heats and vibration builds.
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 17215.04 |
| UPC | 804314037789 |
| Gauge type | Oil pressure |
| Electric or mechanical | Electric |
| Gauge series | Factory Match Jeep |
| Diameter | 2-1/16 inch |
| Mounting | In-dash, O.E. replacement mounting size |
| Face color | Black |
| Units | Standard |
Vehicle fitment
It fits the 1976–1983 Jeep CJ5 (Base, Golden Eagle, Laredo, Limited, Renegade), the 1976–1986 Jeep CJ7 (Base, Golden Eagle, Golden Hawk, Laredo, Limited, Renegade) and the 1981–1985 Jeep Scrambler (Base, Laredo, Renegade, SL, SR).
Wrangler (YJ) and Cherokee (XJ) models are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This gauge reads pressure from a sending unit on the engine. Confirm your engine’s sender before running wire to the gauge.
What’s included
Gather the sender, fittings and wiring you need before starting the install.
















