Overview
The Crown Automotive J5459418 is an electric replacement tachometer that reads 0 to 6000 RPM. A switch on the back selects 4, 6 or 8 cylinder engines. It fits the 1976–1983 Jeep CJ5, the 1976–1986 Jeep CJ7 and the 1981–1985 Jeep Scrambler.
This gauge is wired differently from the original tachometer, and its numbers have no colored bands along the top. The bottom part of the dial does not illuminate because of its design.
Key features
- Reads 0-6000 RPM
- Switch on the back for 4, 6 or 8 cylinder engines
- Electric operation with a black face
- Comes with all mounting hardware
- Standard units
Tachometer wiring and setup
A tachometer reads ignition pulses, so the cylinder setting and the signal wire both matter. Set the switch to the cylinder count before the first start, and verify the signal source on your CJ or Scrambler. A tach that reads double or half the expected speed usually has the wrong cylinder setting.
Because this gauge is wired differently from the original, the harness may need adjusting. Label each wire before disconnecting it, and keep the battery disconnected while working on the electrical connections. Check the reading at idle and under load, since an unstable needle often points to a loose ground or ignition connection.
- Set the cylinder switch before starting
- Label wires before removing the old gauge
- Check the ignition signal wire
- Keep the battery disconnected during wiring
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J5459418 |
| UPC | 848399065695 |
| Electric or mechanical | Electric |
| Gauge type | Tachometer |
| Gauge series | Other |
| Range | 0-6000 RPM |
| Cylinder setting | 4, 6 or 8 (switch on back) |
| Face color | Black |
| Units | Standard |
| Mounting size | O.E. Replacement |
| Fitment | Direct Fit |
Vehicle fitment
The manufacturer list covers the 1976–1983 Jeep CJ5 (Base, Golden Eagle, Laredo, Limited, Renegade), the 1976–1986 Jeep CJ7 (Base, Golden Eagle, Golden Hawk, Laredo, Limited, Renegade) and the 1981–1985 Jeep Scrambler (Base, Laredo, Renegade, SL, SR).
Jeep Wrangler and later models are not on this list, and CJ years outside the ranges above are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Set the switch on the back of the gauge to match your engine’s cylinder count (4, 6 or 8) before use. Because the wiring differs from the original tachometer, compare the connections with your existing harness before installing. Disconnect the battery before wiring the electric gauge.
What’s included
All mounting hardware is included with the tachometer. Not included: a separate wiring harness or sending unit.









