Overview
The Omix-ADA 18676.42 is a front outer bearing retainer for the NP231 transfer case, offered as a direct OE replacement built to original specifications.
No vehicle years or models are named for this retainer, so match the NP231 transfer case in your vehicle before ordering.
Key features
- Direct OE replacement built to original specifications
- Carries a limited five year warranty.
- Made for the NP231 transfer case
Before you replace the retainer
The front outer bearing retainer sits at the output end of the transfer case and holds the output bearing in place. When it comes off, the bearing bore and seal area are exposed, so inspect those surfaces before reassembly. Retainers are commonly replaced along with the seal and gasket whenever the transfer case is opened, since an old seal can allow fluid to seep out once the unit is back in service.
Clean both mating faces thoroughly and make sure the new retainer seats evenly. Tighten the bolts in a crisscross pattern and check the fluid level after the first drives, because a fresh seal can take a short time to settle.
- Replace the output seal when the retainer is removed
- Check the bearing for play or roughness
- Verify that gasket surfaces are clean and flat
- Confirm the retainer matches the NP231 you removed
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 18676.42 |
| UPC | 804314029319 |
| Compatible transfer case | NP231 |
| Warranty | Limited five year warranty. |
Vehicle fitment
Fitment is tied only to the transfer case. The NP231 is the sole transfer case named, and no vehicle year, make or model is given.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
Check the package contents against your installation before starting.









