Overview
The Omix-ADA main bearing set, part number 17465.35, is a standard size set for 6-cylinder engines in 199, 232, 258, 4.2L and 4.0L sizes. It fits Jeep SJ, XJ, CJ, DJ, Comanche, Scrambler, Wagoneer and YJ models from 1972 to 1990.
The set is built to original specifications and carries a five year limited warranty.
Key features
- Standard size main bearing set
- For 6-cylinder engines of 199, 232, 258, 4.2L and 4.0L sizes
- Covers Cherokee SJ and XJ, CJ5, CJ6, CJ7 and Wrangler YJ in the list
- Built to original specifications
Bearing clearance and fit
Main bearings support the crankshaft in the block, and their clearance controls oil film thickness under load. Too little clearance can starve the journal of oil and cause heat damage, while too much causes knocking and oil pressure loss. Clearance depends on the journal diameter and the bearing shell thickness, so both must be measured.
Bearings are usually replaced with the crank out, after the journals have been checked for scoring, taper and out-of-round wear. Undersize shells are sometimes needed when a crank has been ground, but that is a machine shop decision. Use fresh assembly lube on the shells and oil the bearing surfaces before the crank goes back in.
- Check oil pressure after the first start
- Measure journals before choosing shell size
- Inspect the block bore for cracks or heat marks
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 17465.35 |
| UPC | 804314130237 |
| Part type | Main bearing set |
| Size | Standard |
| Engine | 6 cylinder 199, 232, 258, 4.2L and 4.0L |
| Warranty | Limited five year warranty |
Vehicle fitment
Omix-ADA’s list covers 1972 to 1990 Jeep models, including the 1974–1983 Cherokee SJ, 1987–1990 Cherokee XJ, 1972–1983 CJ5, 1976–1986 CJ7, 1987–1990 Comanche, 1981–1985 Scrambler, 1987–1990 Wrangler YJ, and several Wagoneer and J-series trucks in the trims named.
Cherokee and Wrangler models after 1990, and the Wrangler TJ, are not on this list. Match your year, model and trim to the list.
Installation notes
Main bearings are normally replaced during an engine rebuild, with the crankshaft removed and the journals measured. Professional machine work is usually needed to confirm the standard size fits.
What’s included
The set is a main bearing set in standard size.
Not included: crankshaft, gaskets and machine work.









