Overview
The Omix-ADA 16536.02 is an inner rear output shaft cup for the Dana 44 rear axle, used with tapered axle shafts. It fits the 1967 to 1983 Jeep CJ5, the 1972 to 1975 CJ6, the 1976 to 1986 CJ7 and the 1981 to 1985 Scrambler.
A cup is the outer race of a tapered roller bearing, and the axle shaft’s bearing rides on it. This cup is the inner rear output piece for a Dana 44 with tapered shafts, so match it to the bearing on the shaft being replaced.
Matching the cup and bearing
A cup and its tapered roller bearing work as a pair, and the bearing rollers ride on the cup surface. Because the cup and bearing wear together, a worn or pitted cup usually means the bearing has been running on damaged race surfaces. Replacing only one part often leads to early failure of the other.
Before pressing a new cup in, clean the bore and inspect it for burrs or rust. Check the axle shaft bearing and the seal at the same time, since a rebuild typically replaces the whole set. Keep the cup square in the bore when seating it so it does not cock during installation.
- Pitting, scoring or heat marks on the cup
- Blue or dark discoloration on the rollers
- Play in the wheel bearing after assembly
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 16536.02 |
| UPC | 804314005214 |
| Axle | Dana 44 |
| Shaft type | Tapered axle shafts |
| Position | Rear |
Vehicle fitment
It fits the 1967 to 1969 and 1972 to 1983 Jeep CJ5, the 1972 to 1975 CJ6, the 1976 to 1986 CJ7 and the 1981 to 1985 Scrambler, in the Base, Golden Eagle, Laredo, Limited and Renegade CJ trims.
Only the years above are listed. Other CJ years, the Wrangler and the Cherokee are not covered. Confirm your vehicle’s year, model and trim before ordering.
What’s included
One inner rear output shaft cup. No bearing or seal is included with it.








