Overview
The Omix-ADA 16529.07 is a Dana 30 front spindle for disc brake models of the 1979–1985 Jeep CJ5, CJ7 and Scrambler.
A spindle is the machined shaft at the end of the steering knuckle that carries the front wheel bearings and the hub. When a spindle is worn, bent or damaged, replacing it restores a true surface for the bearings and seals to ride on.
The Omix-ADA 16529.07 is a direct OE replacement built to original specifications. It fits the front position on Dana 30 axles and is made for disc brake models.
Spindles on CJ-era Dana 30 front axles bolt into the steering knuckle and locate the inner and outer wheel bearings, so the bearing journals decide how well the wheel runs. Compare the new spindle with the one you remove before assembly. An axle with drum brakes needs a different spindle.
Key features
- Front spindle for the Dana 30 axle
- Made for disc brake models
- Direct fit for the CJ5, CJ7 and Scrambler
- Built to original specifications
- Limited five year warranty from Omix-ADA
Wheel end inspection tips
A front spindle carries the wheel bearings and hub, so any wear or damage on its journals affects the whole wheel end. Before fitting a new spindle, check the old one for scoring, rust pitting and out-of-round wear, and inspect the steering knuckle bore it seats into. A worn spindle makes bearings run hot and loose, and it can cause a steady pull or noise at speed.
Disc brake CJ front ends often have calipers and rotors fitted at the same time, so check the rotor mounting surface and the caliper bracket while the wheel is off. Replace grease seals and bearings whenever the spindle is removed, and repack the bearings with fresh grease. Check bolt torque and wheel alignment after the first drive, since a new spindle can change how the front end sits.
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 16529.07 |
| UPC | 804314044435 |
| Part type | Front spindle |
| Axle | Dana 30 |
| Brake type | Disc brake models |
| Position | Front |
| Warranty | Limited five year warranty |
Vehicle fitment
The 16529.07 spindle fits three Jeep model lines, with these trims:
- 1979–1983 Jeep CJ5 (Base, Golden Eagle, Laredo, Limited, Renegade)
- 1979–1985 Jeep CJ7 (Base, Golden Eagle, Golden Hawk, Laredo, Limited, Renegade)
- 1981–1985 Jeep Scrambler (Base, Laredo, Renegade, SL, SR)
The list stops at the CJ5, CJ7 and Scrambler. Wrangler YJ and TJ models, the Cherokee XJ and CJ models before 1979 are not part of it. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A spindle replacement opens up the whole front wheel end, so the wheel bearings, grease seals and hub hardware are normally inspected or renewed at the same time. Omix-ADA does not publish step-by-step instructions for this spindle, and a professional alignment check afterward is sensible.
What’s included
One Dana 30 front spindle, part number 16529.07.
Not included: wheel bearings, seals, hub hardware and brake parts.









