Overview
The Omix-ADA 18026.03 is a knuckle seal kit for Dana 25 and Dana 27 front axles, sold for the driver or passenger side. Two kits are needed per vehicle, one for each side. Fitment covers Willys and CJ-series Jeeps, Jeepster, Gladiator, Wagoneer and several J-series trucks from 1946 to 1971.
Key features
- Made for the driver or passenger side
- Dana 25 and Dana 27 front axle types
- Two kits required per vehicle
- Position given as Front
Signs the knuckle seal is worn
Knuckle seals keep grease in the steering knuckle and keep dirt out of the hub area on Dana front axles. Worn seals usually show up as grease smears on the backing plate, a slowly dropping grease level or rust near the seal edge. Because the seal sits where the knuckle turns, it is worth checking whenever the front hubs are serviced.
Removing the old seal can damage the knuckle bore, so take care when prying it out. Clean the seating surface and check it for grooves before fitting the new seal. Pack the bearing and seal area with grease as your service manual directs.
- Grease on the backing plate or hub
- Rust or grooves in the knuckle bore
- Hard or cracked seal lip
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 18026.03 |
| UPC | 804314015763 |
| Axle type | Dana 27 and Dana 25 |
| Axle location | Front |
| Side | Driver or passenger |
| Kits per vehicle | Two |
Vehicle fitment
The manufacturer fitment list covers a wide range of vintage Jeep models, including CJ-2, CJ-3, CJ-5, CJ-6, Willys models, Jeepster, Gladiator, Wagoneer (SJ) and J-series trucks, from 1946 through 1971.
The CJ-7 and Wrangler models are not on this list, and no model from 1972 onward is included. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Two kits are required per vehicle, and each kit is made for one side.
What’s included
Check the package contents against your installation before starting.









