Overview
The Omix-ADA 16749.07 is a front brake caliper sleeve that covers one side. It fits 1982–1989 Jeep Cherokee XJ, CJ5, CJ7, Scrambler and Wrangler YJ models.
A caliper sleeve is the sliding sleeve that lets a floating caliper travel along its guide pin as pads wear. This sleeve covers a single side, so a pair of front calipers calls for two.
Omix-ADA describes its range as direct OE replacement Jeep parts built to the original specifications, with a limited five year manufacturers warranty. 16749.07 is marked as a direct fit for the front position, and the model years are fairly narrow.
Sleeves like this one are the guide surfaces for the caliper, so condition matters. A sleeve that is corroded or worn can let the caliper tilt, which eats pads unevenly. Since 16749.07 covers one side only, a pair of front calipers means two sleeves. The vehicle list is also tightly bounded to the early 1980s Jeeps, so a later Cherokee or Wrangler should not be assumed to use the same sleeve.
Key features
- Front brake caliper sleeve
- Covers one side only
- Marked as a direct fit
- Fits early Cherokee, CJ5, CJ7, Scrambler and Wrangler models
- Carries a limited five year manufacturers warranty.
Keeping the guide surfaces sound
The sleeve is one of the guide surfaces the caliper rides on, so its condition controls how the caliper sits in its bracket. When the surface is corroded, scored or worn, the caliper can tilt slightly. That tilt puts uneven pressure on the pads, which wear one edge faster than the other and can leave a pulsing feel under braking.
Remove the sleeve and caliper in a clean area, and inspect the sleeve bore, the bracket surfaces and the guide pin together. Light corrosion can be cleaned off with a wire brush, but pitting or grooves mean the part should be replaced. Coat the contact surfaces with a grease made for brake slide points, and keep it off the pads and rotor.
- Uneven pad wear can come from a tilting caliper
- Clean guide surfaces before reassembly
- Keep grease off pads and rotors
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 16749.07 |
| UPC | 804314050283 |
| Part type | Brake caliper sleeve |
| Position | Front |
| Coverage | One side |
| Fit type | Direct fit |
| Warranty (stated by Omix-ADA) | Limited five year |
Vehicle fitment
Omix-ADA names the 1984–1989 Cherokee (XJ), the 1982–1983 CJ5, the 1982–1986 CJ7, the 1982–1985 Scrambler and the 1987–1989 Wrangler.
Later Cherokees, later Wranglers and CJ models outside those years are not covered by this sleeve. Check your vehicle’s year, model and trim before ordering.
Installation notes
Replacing a sleeve means taking the caliper apart, so bleed the brakes if the hydraulic circuit has been opened and check pedal feel afterward.
What’s included
- Brake caliper sleeve for one side









