Overview
The Omix-ADA 16748.04 is a front left brake caliper hardware kit for the Jeep Cherokee (XJ), Grand Cherokee (ZJ) and Wrangler (YJ, TJ and LJ) models in the manufacturer fitment list.
The 16748.04 is a direct OE replacement built to original specifications and carries a limited five year warranty. Check the package contents against your installation before starting.
About this part
Replace the hardware as a set rather than piece by piece, and compare the old parts against the new ones before assembly. The part is for the front left position. Fitment spans XJ, ZJ, YJ, TJ and LJ models across many years, which reflects a hardware design that stayed in use for a long time. Trims range from Cherokee Base and Laredo to Grand Cherokee Orvis and Limited, and Wrangler Sport, Sahara and Rubicon. Brake parts are usually the same across trims of one model and year, but confirm fit for your vehicle’s year, model and trim before ordering.
Key features
- Brake caliper hardware kit
- Front left position
- Direct fit
- Fitment across XJ, ZJ, YJ, TJ and LJ models
- Limited five year manufacturers warranty
Replacing brake hardware safely
Brake hardware keeps the pads aligned and lets them move freely in the caliper. Over time, clips and pins can corrode, lose tension or wear grooves, which can cause noise, uneven pad wear or a pad that sticks. Pulling the wheel gives a good chance to inspect rotors, pad wear indicators and the caliper slide surfaces at the same time.
Because the fitment spans a long run of model years, match the old hardware to the vehicle before ordering rather than relying on a single model name. Use a light coat of brake-safe lubricant on contact points where a service procedure calls for it, and keep it off the friction surfaces. After installation, pump the pedal before driving and test the brakes at low speed in a clear area.
- Compare every clip and pin with the old set
- Keep lubricant off the pad friction surfaces
- Test the brakes at low speed after the first stop sequence
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 16748.04 |
| UPC | 804314072094 |
| Product type | Brake caliper hardware kit |
| Brake position | Front left |
| Fitment type | Direct fit |
| Warranty | Limited five year manufacturers warranty |
Vehicle fitment
The manufacturer fitment list for the Omix-Ada 16748.04 includes the following vehicles and trims:
- 1990–2001 Jeep Cherokee (XJ) (Base, Briarwood, Classic, Country, Laredo, Limited, Pioneer, SE, Sport)
- 1993–1998 Jeep Grand Cherokee (ZJ) (5.9 Limited, Base, Laredo, Limited, Orvis, SE, TSi)
- 2004–2006 Jeep Wrangler (LJ) (Unlimited, Unlimited Rubicon)
- 1997–2006 Jeep Wrangler (TJ) (65th Anniversary Edition, Rubicon, SE, Sahara, Sport, X)
- 1990–1995 Jeep Wrangler (YJ) (Base, Islander, Laredo, Renegade, Rio Grande, S, SE, Sahara)
The list does not include the JK Wrangler or the WJ Grand Cherokee. Confirm your vehicle’s year, model and trim before ordering.
What’s included
A brake caliper hardware kit. Check the package contents against your installation before starting.
Not included: Calipers, pads and rotors.









