Overview
The Crown Automotive J8120358 is a Dana 30 front axle shaft seal, an inner axle seal that fits the 1971–1973 Jeep Wagoneer (SJ) in Base and Custom trims. Confirm the seal position against your original before fitting it.
The title and short description call it an inner axle seal for the Dana 30 front axle. The position field for the part reads Rear Left, which does not match the front axle wording, so compare the seal with your original before fitting it.
It is a direct-fit replacement for the early SJ Wagoneer, and its fit is limited to the 1971–1973 model years.
A leak at an inner axle seal usually shows up as gear oil on the inside of the axle tube or on the backing plate. Anyone replacing the seal on an early Wagoneer should look at the old part and compare its diameter and depth with this one before pressing the new seal in.
It fits the 1971 to 1973 Wagoneer in Base and Custom trims. No other Jeep model is covered by this seal.
The Wagoneer SJ is a full-size Jeep, and the entry shown in the list is limited to the early 1970s years. Part number J8120358 is the one Crown Automotive matches to those years and trims.
Key features
- Inner axle seal for the Dana 30 front axle
- Fits 1971 to 1973 Wagoneer (SJ)
- Fits Base and Custom trims
- Direct-fit replacement part
- Crown Automotive part number J8120358
Inspecting the old seal
An inner axle seal usually leaks as gear oil on the inside of the axle tube or on the backing plate. Before pressing a new seal in, compare the old seal’s lip, spring and outer diameter with the replacement. Any difference in depth or diameter means the seal is not the right match for the housing.
Pulling the axle gives a good chance to check the bearing for roughness or play. A worn bearing can push oil past a new seal and cause a repeat leak, so address it during the same job. Clean the seal bore, check for grooves, and coat the lip with clean gear oil before installation.
- Compare lip and spring with the old seal
- Check the bearing for roughness or play
- Clean the seal bore and look for grooves
- Lubricate the lip before installing
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J8120358 |
| UPC | 848399066760 |
| Part type | Inner axle seal |
| Axle | Dana 30 front axle |
| Position | Rear Left |
| Fitment type | Direct fit |
| Category | Axle parts, inner axle seals |
Vehicle fitment
The J8120358 seal fits this vehicle:
- 1971–1973 Jeep Wagoneer (SJ) (Base, Custom)
It covers the 1971–1973 Wagoneer (SJ) only. Later and earlier Wagoneer years are not covered. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
This seal is for the Dana 30 front axle, but its position is marked Rear Left. Compare it with your original before fitting.









