Overview
The Omix-ADA 16512.58 is an axle dust slinger for a Dana 30 front axle. It fits the 1999 Jeep Grand Cherokee WJ, the 2004-2006 Wrangler Unlimited LJ and the 1999-2006 Wrangler TJ. It is also cataloged as OAI16512.58 and will not work with CV axles.
It is a direct OE replacement built to original Jeep specifications, with a limited five year warranty.
The slinger is a direct OE replacement built to original specifications, with a limited five year warranty. Check the fit and orientation against your old slinger before installing it.
The main restriction to remember is that CV axles are excluded. Wranglers and Grand Cherokees of these years are listed, but only those with the Dana 30 front axle and the standard shaft arrangement suit this slinger.
The Grand Cherokee WJ appears in the list for 1999 only, which is a narrow window within a generation that otherwise ran longer.
Key features
- Axle dust slinger for the Dana 30 front axle
- Will not work with CV axles
- Direct OE replacement, built to original specifications
- Limited five year warranty.
- Direct fit
Front axle dust and seal protection
The slinger sits on the axle shaft at the front hub and throws off water, mud and grit before they reach the seal. Its job is simple, but it works best when it is straight and seated against the hub. Even a slight bend can let debris track toward the seal lip, which is one of the most common reasons front axle seals wear early on trail-used Jeeps.
When the hub is apart, look at the slinger, the seal lip and the hub face together. Clean any grit from the surfaces and check that the slinger turns freely with no contact. A worn seal is usually easier to replace while the axle is already open than after the slinger has been dragged out of place on a trip.
- Check the slinger for bends
- Inspect the seal lip for grooves
- Replace worn seals while the hub is open
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 16512.58 |
| UPC | 804314028947 |
| Product type | Axle dust slinger |
| Also cataloged as | OAI16512.58 |
| Axle | Dana 30 front |
| Not compatible with | CV axles |
| Fit type | Direct fit |
| Warranty | Limited five year warranty. |
Vehicle fitment
It fits three Jeep models from around 1999 to 2006:
- 1999 Jeep Grand Cherokee (WJ) (Laredo, Limited)
- 2004–2006 Jeep Wrangler (LJ) (Unlimited, Unlimited Rubicon)
- 1999–2006 Jeep Wrangler (TJ) (65th Anniversary Edition, SE, Sahara, Sport, X)
The 1999 Grand Cherokee WJ covers only that year. The 2000-2004 WJ, YJ, XJ and JK are not covered. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Confirm the Dana 30 front axle uses a standard shaft, since the slinger will not work with CV axles.
What’s included
One axle dust slinger.












