Overview
The Moog K80827 is a press-in front lower ball joint, part number MOGK80827, for the Toyota Tacoma. It fits the 2005–2019 Tacoma across the Base, Limited, Pre Runner, SR, SR5, TRD Off-Road, TRD Pro, TRD Sport and X-Runner trims.
A lower joint carries the wheel’s pivot point at the bottom of the front suspension, so it wears over time and needs replacing once looseness appears. This replacement adds a hardened ball stud and a forged housing, and it can be greased through the fitting. The design is newer, so the part may look different from older photos.
Key features
- Press-in installation into the steering knuckle
- Greasable joint with a pre-tapped grease fitting hole
- Hardened ball stud, made of materials Moog rates as OE equivalent or better
- Patent-pending dust boot with an encapsulated Belleville washer
- Forged housing with increased material in key areas
- Greasable socket that flushes contaminants out with new lubricant
Before you buy
A worn lower ball joint often shows up as a clunk over bumps, play in the wheel when it is rocked at the top and bottom, or uneven tire wear along one edge of the tread. Looking at the dust boot for splits and checking for grease at the fitting are quick first steps before any teardown. Because the joint is part of the wheel’s pivot, a loose one changes steering feel and should not be left in service.
Front lower joints often wear as a pair, since both sides see similar road loads. When the knuckle is already apart, the opposite side is worth inspecting too. Press-in replacements also change how the wheel sits, so an alignment afterward is the normal next step, and checking the upper joint for play during the same job is practical.
Specifications
| Brand | Moog |
|---|---|
| Part number | MOGK80827 |
| Position | Front lower |
| Joint type | Press-in |
| Lubeable | Yes |
| Housing | Forged, with up to 52% more material in key areas |
Vehicle fitment
Moog’s list covers the 2005–2019 Toyota Tacoma in every trim it names, including the TRD Pro and TRD Off-Road versions.
Toyota trucks other than the Tacoma, including the 4Runner and Tundra, are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
As a press-in joint, it needs a press or the correct installation tools. The part should be pressed squarely into the knuckle, and the grease fitting used once it is seated.
What’s included
One Moog front lower ball joint, part MOGK80827.










