Overview
The Moog K3137T is a press-in front lower ball joint for the 1984–1989 Jeep Cherokee (XJ), 1984–1989 Wagoneer (SJ), 1987–1989 Wrangler (YJ) and 1986–1989 Comanche. It is greasable, with a reservoir and grease fitting designed for regular maintenance.
The dust boot has an encapsulated Belleville washer that limits axial and radial movement. The powdered metal bearing carries grease to the hardened ball stud, and the socket can be greased so fresh lubricant pushes contaminants out.
Key features
- Press-in type for the lower control arm
- Greasable socket, which Moog says flushes contaminants
- Larger grease reservoir for longer service intervals
- Dust boot with a Belleville washer for axial and radial control
- Powdered metal gusher bearing.
- Hardened ball stud for higher loads
Inspecting a lower ball joint
The lower ball joint carries the weight of the front end and lets the wheel pivot as the suspension moves, so it sees steady load on every mile. Wear usually starts as small play in the stud or socket, then grows into clunks and sloppy steering. Check it with the wheel off the ground by feeling for movement between the knuckle and the control arm while someone rocks the tire.
Because the joint is press-in, most owners replace it as a unit rather than rebuilding it. Replacing the lower joint at the same time as the upper joint on the same side keeps the wheel geometry consistent. After installation, have the front alignment checked, since a joint change can alter camber and caster.
- Clunking over bumps
- Play at the wheel when rocked
- Torn or missing dust boot
- Uneven front tire wear
Specifications
| Brand | Moog |
|---|---|
| Part number | K3137T |
| Position | Front lower |
| Installation type | Press-in |
| Lubeable | Yes, pre-tapped grease fitting hole |
Vehicle fitment
The K3137T fits these vehicles:
- 1984–1989 Jeep Cherokee (XJ), in Base, Chief, Laredo, Limited, Pioneer and Sport versions
- 1986–1989 Jeep Comanche, in Base, Chief, Custom, Eliminator, Laredo, Pioneer, X and XLS versions
- 1984–1989 Jeep Wagoneer (SJ), in Base and Limited versions
- 1987–1989 Jeep Wrangler (YJ), in Base, Islander, Laredo, S, Sahara and Sport versions
Jeep models after 1989, and the Wrangler TJ, are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The joint is a press-in type, so the control arm must be pressed or supported during installation. The grease fitting hole is pre-tapped, so the fitting can be installed without tapping the housing.
What’s included
Check the package contents against your installation before starting.










