Overview
The Max-Bilt 3 Speed Reverse Switch Kit TT-90 is a reverse light switch for older flat fender CJ Jeeps. It turns on reverse lights when the transmission is shifted into reverse.
The plate bolts to the transmission shifter housing, and the switch is wired into the reverse light circuit. It is a way to add reverse lights to an older CJ.
Key features
- Reverse light switch for older flat fender CJ Jeeps
- Plate bolts to the transmission shifter housing
- Switch wires into the reverse light circuit
- Max-Bilt part number MBLTT-90
Adding reverse lights
Reverse light circuits are simple: the transmission closes a switch when it is in reverse, sending power to the lamps. A plate-mounted switch works the same way, so the wiring behind the dash and the lamp fuses matter as much as the switch itself.
Use connectors that resist vibration and moisture, since the floor area of an older CJ gets wet and dirty. Keep wiring away from the exhaust and moving linkage, and confirm the lamps have a good ground. Check the switch after the first few drives, because a loose plate can shift and change the switch position.
- Test the lamps in reverse before the trim goes back
- Route wire away from exhaust heat
- Check the ground at the lamp housings
Specifications
| Brand | Max-Bilt |
|---|---|
| Part number | MBLTT-90 |
| Kit type | 3 Speed Reverse Switch Kit |
| Model | TT-90 |
| Mounting | Bolts to transmission shifter housing |
| Wiring | Into reverse light circuit |
Vehicle fitment
It is made for older flat fender CJ Jeeps, with no years or chassis codes given. Confirm your CJ model and transmission shifter housing before fitting.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Bolt the plate to the transmission shifter housing, then wire the switch into the reverse light circuit. Disconnect the battery before running wire to the reverse lights.
What’s included
The kit includes the switch and a mounting plate.
Not included: Reverse lights and their wiring.











