Overview
The Insane Jeep Audio InsaneASD, part number I/EInsaneASD, is an auto start-stop controller that lets you decide when Auto Start-Stop is enabled on a Jeep Wrangler JL or Gladiator JT. It fits 2018–2026 Jeep Wrangler (JL) and 2020–2026 Jeep Gladiator (JT) models.
The control box takes back control of the factory Auto Start-Stop function. Installation takes 5 minutes, and it plugs in between the OEM cable, so no wires are cut. Drivers who see the engine shut off when they step into the house, or who dislike how it feels at a stoplight, can disable the feature and return to OEM mode whenever they like.
Key features
- Lets you choose when Auto Start-Stop is enabled and when it is not
- Uses the factory OEM start-stop button, so no new switch is needed
- A long press (hold the button down) disables OEM auto start-stop, and a beep confirms it
- Hold the button down again to return to OEM mode
- Plugs in between the OEM cable with no cutting of wires
- Fits all JL Wranglers and JT Gladiators
- 3 Year limited warranty
Living with auto start-stop
Auto start-stop shuts the engine off at stops to save fuel and reduce idle time. The trade-off is that the engine restarts many more times in heavy traffic, which places extra load on the battery and starter. Controlling when the feature runs lets you choose the balance that suits your driving, whether that means keeping it active on highway commutes or turning it off for trail and town use.
Battery condition plays a large role in how well start-stop behaves. A weak or aging battery may cause the system to stay in run mode or restart less smoothly, so keep the terminals clean and secure. Pay attention to how the engine restarts over the first few weeks of use, since a change in restart behavior is an early sign of a battery or starter problem.
- Battery health affects how often the engine shuts off
- Keep battery terminals clean and tight
- Watch for slow or rough restarts
Specifications
| Brand | Insane Jeep Audio |
|---|---|
| Part number | I/EInsaneASD |
| Product type | Auto start-stop controller (ASD module) |
| Compatible Jeep models | JL Wrangler and JT Gladiator |
| Fitment type | Direct Fit |
| Installation | Plugs in between the OEM cable |
| Activation | Long press the OEM start-stop button |
| Warranty | 3 Year limited warranty |
Vehicle fitment
The manufacturer fitment list covers the 2020–2026 Jeep Gladiator (JT) in Altitude, High Altitude, Launch Edition, Mojave, Overland, Rubicon, Sport, Sport S, Willys and Willys Sport trims. It also covers the 2018–2026 Jeep Wrangler (JL) in 2-door trims (80th Anniversary, Freedom, Islander, Rubicon, Sport, Sport S, Willys, Willys Sport) and Unlimited 4-door trims (80th Anniversary, Freedom, Islander, High Altitude, Moab, Rubicon, Rubicon 392, Sahara, Sahara Altitude, Sport, Sport Altitude, Sport S, Willys, Willys Sport).
Earlier Wrangler generations such as TJ and JK, and other Jeep models, are not covered by this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Installation is a plug-in job between the OEM cable, so no wire cutting is needed. Because the controller works with the start-stop system wiring, disconnect the battery before plugging it in. Once installed, a long press of the OEM start-stop button disables auto start-stop, and holding it again returns the vehicle to OEM mode.
What’s included
It works with the factory OEM start-stop button already on the vehicle. Compare the box contents with your installation plan before starting.











