Overview
The Kentrol 54 Inch Front Stainless Steel Bumper without Holes, part number 30430, is made of 304 grade stainless steel with a solid face and pre-drilled license plate mounting holes. It fits the Jeep CJ5, CJ6, CJ7 and Scrambler.
The tube is 4 inch x 2 inch diameter, and stainless steel hardware is included. For rear use, bracket part 30508 for CJs is needed.
The stainless steel is designed to resist rust. An occasional waxing helps keep the mirror-like shine.
Key features
- 304 grade stainless steel
- Pre-drilled license plate mounting holes
- Listed tube size of 4 inch x 2 inch diameter
- Includes stainless steel hardware
- Stainless finish that Kentrol says keeps its mirror-like shine with occasional waxing
Front bumper install tips
Mounting a front bumper on a CJ starts with checking the frame and the existing mounting points. Look for rust, cracks or bent brackets before attaching anything, since the bumper carries impact loads.
Solid faces give a clean look and hide the mounting area behind them, while pre-drilled plate holes make it simpler to fit a license plate on the bumper. Hold the plate in place before tightening so the holes line up with the bracket. Keep a small kit of spare fasteners in the vehicle for trail use.
Use the stainless hardware for every bolt and tighten them evenly. Recheck the fasteners after the first few drives, especially on rough roads, because bolts can loosen as the vehicle settles.
- Inspect frame mounts before installation
- Hold the license plate before final tightening
- Recheck fasteners after the first drives
Specifications
| Brand | Kentrol |
|---|---|
| Part number | 30430 |
| UPC | 812421020334 |
| Product type | Front bumper |
| Length | 54 inch |
| Material | 304 grade stainless steel |
| Finish | Stainless steel |
| License plate holes | Pre-drilled |
| Tube size | 4 inch x 2 inch diameter |
| Hardware | Included, stainless |
| Width | Full |
| Light mounts | Not included |
| Winch mount | Not included |
| D-ring mount | Not included |
Vehicle fitment
It fits the 1959–1983 Jeep CJ5, the 1959–1975 CJ6, the 1976–1986 CJ7 and the 1981–1985 Scrambler.
Listings for the later Wrangler (YJ) are separate part numbers. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
To mount this bumper onto the rear, bracket part 30508 for CJs is required.
What’s included
The bumper and stainless steel hardware.
Not included: bracket part 30508, needed for rear mounting on a CJ.









