Overview
The Jeep hardtop switch and wiring kit, part number 82212860, is a Jeep-branded kit for adding a Mopar hardtop to a soft top Jeep. It supplies the switch and harness needed to use the hardtop features of a factory hardtop, including rear wiper control.
The kit is universal fit, so compatibility depends on your own vehicle. It is intended for owners who want the features of a factory hardtop on a soft top Jeep.
Key features
- Multifunction switch for the rear wiper
- Wiring harness for hardtop electrical features
- Designed to give a soft top Jeep the features of a factory hardtop
- Installation CD included
- Cutting and splicing required during installation
Wiring work before you start
This kit needs cutting and splicing, which turns installation into a wiring job rather than a plug-in swap. Before anything is cut, locate the existing harness, identify each wire by its function and sketch the layout. A simple written map saves time when the rear wiper and hardtop circuits need testing later.
Use proper crimp or solder connections with heat shrink over every joint, and avoid twisting bare wires together. Protect repaired sections from hinges, frame edges and water, since flexing and moisture are common causes of failure in rear wiring. Tape alone rarely holds up on a circuit that sees vibration.
Test the circuit before reassembling the interior trim. Confirm the wiper, switch and hardtop functions work as expected, then secure the harness so it cannot rub or sag. A loose or chafed splice is the most likely problem to appear after the first few trips.
- Disconnect the battery before cutting
- Label each wire before splicing
- Seal every joint with heat shrink
- Run a full function test before reassembly
Specifications
| Brand | Jeep |
|---|---|
| Part number | 82212860 |
| UPC | 70000579341 |
| Fitment type | Universal fit |
| Components | Multifunction rear wiper switch, wiring harness, installation CD |
Vehicle fitment
It is universal fit and is meant for a soft top Jeep being fitted with a Mopar hardtop. Confirm fit for your vehicle’s year, model and soft top setup before ordering.
Other Jeep generations or models are not confirmed for this kit. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Cutting and splicing are required, so plan for wiring work on the vehicle and disconnect the battery before you begin.
What’s included
Multifunction rear wiper switch, wiring harness and installation CD.
Not included: the Mopar hardtop, which this kit is designed to be fitted with.









