Overview
The Jeep 68003276AA is a rear caliper adapter mounting bolt for the 2007–2016 Jeep Wrangler JK. It is a factory style replacement brake caliper bolt in an M12 x 1.50 x 30.00 size, for 2-door and 4-door Wranglers.
A caliper adapter is the bracket that carries the brake caliper, and this bolt fastens that adapter at the rear axle. The M12 x 1.50 x 30.00 size follows the usual metric pattern of thread diameter, thread pitch and length, which makes it easy to compare with the bolt being replaced. It suits an owner who wants original-style hardware rather than a change to the brake setup.
Key features
- Rear caliper adapter mounting bolt for the Wrangler JK
- Factory style replacement part sold under the Jeep brand
- Metric size M12 x 1.50 x 30.00
- Fits 2-door and 4-door models
- Fitment list covers model years 2007 through 2016
Rear caliper hardware check
A caliper adapter bolt holds a load-bearing part of the rear brake assembly, so its condition matters more than its size alone. Check the threads in the adapter for damage, and look at the bolt head and shank for stretching, corrosion or nicks before refitting an old bolt.
Thread engagement matters. Start the bolt by hand so it runs in straight, then tighten in steps with a quality tool. Keep the mounting faces clean of rust, dirt or old sealant so the adapter seats flat against the axle flange and holds its setting over time.
- Inspect the bolt for stretching or corrosion
- Clean the adapter and flange faces
- Start threads by hand to avoid cross-threading
- Replace any bolt with damaged threads
Specifications
| Brand | Jeep |
|---|---|
| Part number | 68003276AA |
| UPC | 70000547589 |
| Part type | Caliper adapter mounting bolt |
| Position | Rear |
| Size | M12 x 1.50 x 30.00 |
| Body styles | 2 and 4-door models |
| Part style | Factory style replacement part |
| Category | Disc brake caliper bolt |
Vehicle fitment
It fits the 2007–2016 Jeep Wrangler (JK), covering the two-door Wrangler and the four-door Wrangler Unlimited. Trims range from Sport and Sahara to Rubicon and the 70th and 75th Anniversary editions.
It fits only the JK generation. The 2017–2018 Wrangler JK years, the JL and the earlier TJ and YJ are not covered. Match your year, model and trim to this part before ordering.
Installation notes
Because the bolt holds the rear caliper adapter, match the full M12 x 1.50 x 30.00 size to the old bolt before installing; a different thread pitch or length will not seat correctly. Use the tightening specification from the Jeep service procedure for the rear adapter.
What’s included
- One caliper adapter mounting bolt, part 68003276AA. Check the package contents against your installation before starting.
Not included: the caliper adapter, caliper, brake pads or rotor.









