Overview
The Jeep 82212859 is a hardtop switch and wiring kit for fitting a Mopar hardtop to a soft-top Jeep. It is needed to use the features of a factory hardtop. The kit includes a new multifunction switch for the rear wiper and new HVAC controls with a rear defroster.
The kit comes with what is needed for those factory hardtop features. Cutting and splicing is required during installation.
Key features
- Multifunction switch for the rear wiper
- New HVAC controls with rear defroster
- Complete set for factory hardtop features
- Requires cutting and splicing
Planning the wiring job
Cutting and splicing turn a hardtop fit into a wiring project. Good results come from planning the route first, confirming which wires feed the rear wiper and rear defroster, and testing each circuit as you go. Crimped and heat-shrunk splices hold up better than taped joints in wet or dusty conditions.
Labeling every wire before cutting makes reassembly far simpler, and a multimeter check confirms continuity before you close up the trim. Work with the battery disconnected, and keep splices away from hot exhaust parts and sharp body edges. If HVAC controls are replaced, check that the new switches connect cleanly before the dash is reassembled.
- Label each wire before cutting
- Test circuits before closing the trim
- Use crimped, heat-shrunk splices
Specifications
| Brand | Jeep |
|---|---|
| Part number | 82212859 |
| UPC | 70000579340 |
| Includes | Multifunction rear wiper switch and new HVAC controls with rear defroster |
| Installation | Cutting and splicing required |
| Application | Soft-top Jeep with Mopar hardtop |
Vehicle fitment
No year, model or chassis code is given for this kit, so fit for a specific Jeep is not confirmed.
Use it on a soft-top Jeep being fitted with a Mopar hardtop. Match your year, model and trim before ordering.
Installation notes
Expect wire work during installation, since cutting and splicing are required. Disconnect the battery before cutting or splicing any wiring.
What’s included
A multifunction switch for the rear wiper and new HVAC controls with a rear defroster, plus the wiring needed to use the factory hardtop features.
Not included: The Mopar hardtop itself.









