Overview
The Jeep 68003699AA is a front disc brake caliper adapter for the 2007–2017 Jeep Wrangler. It is a factory style replacement part that fits 2-door and 4-door models.
A caliper adapter, also called a caliper bracket, is the mounting piece that sits between the steering knuckle and the brake caliper at the front axle. It keeps the caliper aligned with the rotor, so a damaged adapter can cause uneven pad wear or noise. This one is a direct fit listing for the Wrangler JK generation. When this adapter is replaced, the same visit is a good opportunity to check the front rotor, the pad wear and the condition of the caliper slides. The adapter mounts to the steering knuckle, so it is part of the structure that holds the entire front brake in place.
Key features
- Front disc brake caliper adapter
- Also known as a caliper bracket
- Factory style replacement part under the Jeep brand
- Fits 2-door and 4-door models
- Direct fit listing for the 2007–2017 Wrangler
Before you buy
A front caliper adapter carries a lot of braking load over its service life, so it is worth looking at the whole front brake assembly before fitting a new one. Rust on the mounting face, bent bracket arms and bolts that have been overtightened are common signs that the old part has worn. Inspect the steering knuckle surface for corrosion or pitting, since a new adapter will not seat properly against a damaged face. Check the caliper slides for free movement and clean out old grease, because stiff slides can cause the same uneven pad wear that a bent adapter does.
If the front rotors or pads are due for replacement, doing them during the same visit saves time and keeps the caliper position consistent. Use new mounting bolts rather than reusing stretched ones, and keep a torque wrench on hand for the value given in the service procedure. Brake fluid and hose condition are worth a look at the same time, since the caliper stays connected to them.
Specifications
| Brand | Jeep |
|---|---|
| Part number | 68003699AA |
| UPC | 70000547593 |
| Part type | Disc brake caliper adapter |
| Position | Front |
| Body styles | 2 and 4-door models |
| Part style | Factory style replacement part |
| Fit type | Direct fit |
Vehicle fitment
The 68003699AA fits the 2007–2017 Jeep Wrangler (JK), including two-door and four-door models, so Wrangler Unlimited vehicles are covered as well. Its year range runs one year longer than the rear adapter for the same generation, so the 2017 model year is covered by this front part.
The 2018 Wrangler JK and the JL generation are not covered by this adapter, and older Wranglers such as the TJ do not fit. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
This adapter carries the front caliper, so install it with correctly sized mounting bolts and follow the Jeep service procedure for tightening. Check the rotor and caliper slide hardware while the adapter is off. Because the adapter bolts to the steering knuckle, make sure the mating surface is clean and flat before installing, and replace any mounting bolts that show stretched or damaged threads.
What’s included
- One front disc brake caliper adapter, part 68003699AA
Not included: the brake caliper, mounting bolts, brake pads or rotor.









