Overview
The Power Stop S5046 is a rear pair of powder-coated performance brake calipers for the 2007–2011 Dodge Nitro, 2008–2012 Jeep Liberty and 2007–2016 Jeep Wrangler. The set holds one left and one right caliper.
Power Stop says these calipers are made for enthusiasts and bolt directly in place of the originals. The caliper and bracket are remanufactured in Power Stop’s Chicago, IL facility and finished in a red powder coat for high temperature. Premium boots and seals are new, and the pins get silicone lubricant. For a Wrangler JK, rear calipers are exposed to dirt, water and salt on the trail, and a pair that no longer slides freely leaves the pads dragging.
Key features
- Rear pair with left and right calipers
- Direct bolt-in replacement for the stock rear calipers.
- Remanufactured in Power Stop’s Chicago, IL facility
- High-temperature red powder coat
- New premium boots and seals
- High-temperature silicone lubricant on the pins
- Premium abutment clips where applicable
Rear calipers on a trail rig
Rear calipers on a trail-driven Wrangler are exposed to mud, water, sand and road salt, which can wash grease from the pins and corrode the slide surfaces. A rear caliper that no longer moves freely can drag, heat the rotor and cause the rear pads to wear unevenly. Keeping the pins clean and lubricated is one of the simplest ways to prevent this.
Rear pairs are often serviced together with the parking brake, so check that mechanism during installation as well. After fitting, bleed the brakes and confirm a firm pedal before driving on rough terrain. Inspect the brake lines for chafing, because off-road use can rub hoses against brackets and rocks.
- Clean and lubricate slide pins at every pad change
- Check parking brake engagement after installation
- Inspect brake lines for chafing from rocks and brush
Specifications
| Brand | Power Stop |
|---|---|
| Part number | S5046 |
| UPC | 792088848338 |
| Part type | Performance brake calipers |
| Position | Rear |
| Set contents | 1 left caliper and 1 right caliper |
| Finish | High-temperature red powder coat |
| Remanufactured in | Chicago, IL facility |
| Fit type | Direct fit |
Vehicle fitment
The S5046 fits the 2007–2011 Dodge Nitro, the 2008–2012 Jeep Liberty and the 2007–2016 Jeep Wrangler.
Be sure your year, model and trim match before ordering. Years outside those ranges are not covered, including the 2017–2018 Wrangler JK and the JL. This is a rear set, so it does not replace front calipers.
Installation notes
The S5046 is a direct replacement for the stock rear calipers. Check the parking brake after installation, bleed the brakes, and confirm the pedal is firm before regular driving.
What’s included
- Rear left caliper and rear right caliper
- Brackets remanufactured with the calipers
- New premium boots and seals
- High-temperature silicone for the pins
- Premium abutment clips where applicable
Not included: pads, rotors, brake fluid and any hardware not named above.








