Overview
The Jeep 68003775AA is a rear disc brake caliper adapter for the 2007–2016 Jeep Wrangler. It is a factory style replacement part for 2-door and 4-door models.
The adapter, sometimes called a caliper bracket, holds the rear brake caliper in line with the rotor and takes the clamping force of the pads. When it is bent or corroded, the caliper can no longer slide correctly. This part is a direct fit listing for the Wrangler JK at the rear axle. A rear adapter that has rusted or bent can leave the caliper sitting at an angle, which shows up as uneven pad wear or brake noise. Replacing it restores the correct caliper position for the rear pads and rotor, and it is worth checking the caliper slides at the same time.
Key features
- Rear disc brake caliper adapter
- Also called a caliper bracket
- Factory style replacement part under the Jeep brand
- Fits 2-door and 4-door models
- Direct fit listing for the 2007–2016 Wrangler
Rear brake service tips
The rear caliper adapter holds the caliper over the rotor and carries the pad load every time the brakes are applied. Because rear pads often wear differently from front pads, the rear adapter is worth inspecting when brake noise or uneven wear shows up. Look for bent arms, cracks near the bolt holes and a rusty mounting face. Any of these can keep the caliper from sliding freely, which holds one pad against the rotor longer than the other.
When the adapter comes off, check the caliper slide pins and boots for grease loss or corrosion, and clean the pin bores before reassembly. Fresh caliper grease, new pads and new bolts are usually the sensible additions. Check the brake hose connection if it was disturbed, and test the brakes at low speed before driving normally.
Specifications
| Brand | Jeep |
|---|---|
| Part number | 68003775AA |
| UPC | 70000547592 |
| Part type | Disc brake caliper adapter |
| Position | Rear |
| Body styles | 2 and 4-door models |
| Part style | Factory style replacement part |
| Fit type | Direct fit |
Vehicle fitment
The 68003775AA fits the 2007–2016 Jeep Wrangler (JK), covering both the two-door Wrangler and the four-door Wrangler Unlimited. It is a rear part with a year range that ends in 2016, one year before the front adapter for the same generation, so the 2017 JK is not covered by this rear adapter.
The 2017 and 2018 JK years and the later JL are not covered by this adapter. It is a rear part and does not replace the front adapter. Check that your year, model and trim match before ordering.
Installation notes
Because this adapter holds the rear caliper, mount it with the correct caliper bolts and follow the Jeep service procedure for tightening. Inspect the rear caliper slides and pads while the bracket is removed. Clean the rear mounting face before installing the new adapter, and replace any hardware that shows damaged threads or heavy corrosion.
What’s included
- One rear disc brake caliper adapter, part 68003775AA
Not included: the brake caliper, mounting bolts, brake pads or rotor.









