Overview
The Power Stop S4836 is a rear pair of powder-coated performance brake calipers with brackets for the 2007–2009 Chrysler Aspen, 2004–2009 Dodge Durango, 2004 and 2006–2010 Dodge Ram 1500, and 2011–2013 and 2015 Ram 1500. The set has one left and one right caliper.
Power Stop designs these calipers for enthusiasts and says they bolt in place of the stock rear calipers. Caliper and bracket are remanufactured in the USA, finished in a high-temperature red powder coat, and fitted with new premium boots and seals. Silicone lubricant that handles high temperature is applied to the caliper pins, and abutment clips are included where they apply. A rear caliper that sticks drags the pad against the rotor, heating the wheel and wearing the pad, so full-size trucks and SUVs that tow benefit from a fresh matched pair.
Key features
- Rear pair with left and right calipers
- Calipers listed with brackets
- Bolt-in replacement for stock calipers
- Remanufactured in the USA
- High-temperature red powder coat
- New premium boots and seals
- High-temperature silicone lubricant on the pins
- Premium abutment clips where applicable
Parking brake and rear service
Rear calipers on full-size trucks and SUVs often carry a parking brake mechanism inside the housing. When a caliper is replaced, the parking brake linkage has to move freely and engage fully, or the truck may roll on a grade. Test the lever or pedal after the job and make sure the rear wheels turn freely when the parking brake is released.
Rear pads wear differently from front pads on a loaded vehicle, so a fresh pair of calipers is best paired with new pads and inspected rotors. Hoses and banjo fittings should be checked for seepage at the same time. A caliper that drags leaves the pad against the rotor, so heat and an unusual smell after a short drive are signs to investigate.
Specifications
| Brand | Power Stop |
|---|---|
| Part number | S4836 |
| UPC | 792088929938 |
| Part type | Performance brake calipers with brackets |
| Position | Rear |
| Set contents | 1 left caliper and 1 right caliper |
| Finish | High-temperature red powder coat |
| Remanufactured in | USA |
| Fit type | Direct fit |
Vehicle fitment
The S4836 fits the 2007–2009 Chrysler Aspen, the 2004–2009 Dodge Durango, the Dodge Ram 1500 for 2004 and 2006–2010, and the Ram 1500 for 2011–2013 and 2015.
Ram 1500 years 2005, 2014 and 2016 and newer are not covered, and 2500 and 3500 trucks are not part of this rear set. Match your exact model year. Make sure the year, model and trim match your vehicle before ordering.
Installation notes
The calipers bolt directly in place of the stock units. Rear brakes on these trucks often include a parking brake mechanism, so check its operation after installation, bleed the brakes and confirm pedal feel.
What’s included
- Rear left caliper and rear right caliper
- Brackets included with the set
- New premium boots and seals
- High-temperature silicone for the caliper pins
- Premium abutment clips where applicable
Not included: pads, rotors, brake fluid and any hardware not named here.







