Overview
The Crown Automotive 68003775AA is a rear brake caliper bracket for the 2007–2011 Dodge Nitro, 2008–2012 Jeep Liberty and 2007–2018 Jeep Wrangler. It fits the rear driver side or passenger side.
A caliper bracket holds the brake caliper in the right position over the rotor, so a bent, cracked or missing bracket affects the whole rear brake assembly. Crown Automotive has made replacement parts for Jeep vehicles for many years. One part number covers either rear side, so the same bracket serves the driver and passenger positions. Inspect the opposite bracket when replacing one, since both sit in the same road grime and moisture.
Key features
- Rear brake caliper bracket
- Fits rear driver or passenger side
- Direct fit listing
- Covers the Dodge Nitro, Jeep Liberty and Jeep Wrangler
- Crown Automotive replacement part for Jeep vehicles
Rear bracket inspection
The rear caliper bracket takes the braking load of the caliper, so cracks, bent ears or loose mounting holes show up as pad noise, uneven wear or a caliper that rattles over bumps. Dirt, road salt and water collect around the bracket, and surface rust often hides a crack underneath. Clean the bracket and look closely at the bolt holes before deciding it is still sound.
Because both rear brackets see the same conditions, check the opposite side at the same time. Use new bolts whenever the bracket comes off, and make sure the caliper slides move freely once it is back in place. The bracket should sit flush against the axle housing without forcing it into position.
- Look for cracks around the caliper bolt holes
- Replace any bent or corroded hardware
- Confirm the caliper slides move freely
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 68003775AA |
| UPC | 849603004103 |
| Part type | Brake caliper bracket |
| Position | Rear |
| Side | Rear driver or passenger side |
| Fit type | Direct fit |
Vehicle fitment
The bracket fits the 2007–2011 Dodge Nitro, the 2008–2012 Jeep Liberty and the 2007–2018 Jeep Wrangler. The Wrangler range covers the full JK generation from 2007 through 2018. The Nitro and Liberty share the era and platform family of the Wrangler JK, which is why one rear bracket fits all three.
Model years outside those ranges are not covered, including the Wrangler JL and the earlier Liberty. The bracket is for the rear axle only and does not replace a front bracket. Match your year, model and trim to these ranges before ordering.
Installation notes
The bracket carries the rear caliper, so install it with the caliper bolts that match the vehicle and use the Jeep service procedure for tightening. Because it fits either side, the same part number works for a driver or passenger replacement. Clean the bracket’s mounting face and the caliper slide surfaces before assembly so the caliper can move freely, and replace any damaged bolts at the same time.
What’s included
- One rear brake caliper bracket, part 68003775AA
Not included: the brake caliper, mounting bolts, brake pads or rotor.









