Overview
The JBA Headers 063-1204 is a 3 bolt, 3 in. wire gasket for the exhaust header connection, part number JBA063-1204. JBA describes these gaskets as extra thick and made from a specially formulated gasket material. Each one is designed for an exact match with JBA headers.
The gaskets are rated up to 1100 F and handle exhaust pressures up to 3700 psig. They carry a Limited One Year Warranty.
Key features
- Extra thick gaskets made from a specially formulated gasket material
- Rated up to 1100 F
- Handles exhaust pressures up to 3700 psig
- Designed for an exact match with JBA headers
Gasket sealing basics
A wire gasket seals the header-to-collector joint by compressing into the flange surfaces under heat and pressure. Its job depends on flat, clean sealing faces, so remove any old residue and inspect both flanges before fitting a new one. Light surface rust can usually be cleaned off, but pitting or warping calls for header repair.
Because exhaust joints expand and contract with every heat cycle, retighten the fasteners after the first few runs and look for soot streaks that point to a leak. Matching the gasket with the correct bolts and studs keeps clamp load even around the flange.
- Clean both flange faces before installing
- Check for soot streaks after the first heat cycles
- Replace the gasket if the seal is disturbed
Specifications
| Brand | JBA Headers |
|---|---|
| Part number | JBA063-1204 |
| Gasket type | 3 bolt, 3 in. wire gasket |
| Temperature rating | Up to 1100 F |
| Exhaust pressure rating | Up to 3700 psig |
| Warranty | Limited One Year Warranty |
Vehicle fitment
No vehicle is named for these gaskets. They are designed for JBA headers, so confirm that your header is a JBA model before ordering.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
Check the package contents against your installation before starting, and confirm you have the bolts and any header hardware you need.








