Overview
The ICON Vehicle Dynamics ICO48612 is a rear EXP coilover shock absorber for the 2021 to 2026 Ford Bronco equipped with the HOSS 2.0 suspension package. It keeps the factory coil spring and other components, and on HOSS 2.0 trucks it gives 0 to 3 inches of rear ride height adjustment over stock, so the rear can be left at stock height or raised.
The shock uses a 2.5-inch aluminum body with a larger piston area than the smaller steel OE shock. This improves damping and heat dissipation, which supports longer service during long runs at higher speed or on rougher terrain. The digressive piston is tuned for the Bronco and works with the stock coil springs, and the shock can be fully revalved and rebuilt.
Key features
- Re-uses the Bronco’s factory coil spring and OEM upper mounts
- Snap-ring grooves for 0 to 3 inches of rear lift over stock
- Hard anodized one-piece aluminum body
- 7/8-inch induction hardened and chrome plated shaft
- One-piece digressive piston design
- Fully rebuildable and revalveable
Rear shock service life
A rear shock works with the coil spring and the upper mount to control body movement and keep the tires in contact with the ground. Over time the shock oil breaks down and seals wear, leading to leaks, reduced damping or a bouncy ride. Check the shock body for oil streaks, inspect the eyelet and mounting bushings for cracks, and listen for knocking over bumps. Replacing shocks in pairs keeps the rear damping balanced.
A shock that can be rebuilt and revalved gives options as the truck’s use changes. Heavier loads, larger tires or more frequent trail driving all place more demand on the damper, so service intervals may come sooner. Keep the shaft clean and free of grit, and inspect the chrome shaft for pitting, which can damage the seal. Before installing new shocks, check the spring and upper mounts for wear and tighten all hardware to the vehicle’s specifications.
Specifications
| Brand | ICON Vehicle Dynamics |
|---|---|
| Part number | ICO48612 |
| Shock series | 2.5 Coilover |
| Shock type | Coilover |
| Body diameter | 2.5 inches |
| Shaft diameter | 7/8 inch, induction hardened, chrome plated |
| Top mount | OEM |
| Bottom mount | Eyelet |
| Lift range | 0 to 3 inches over stock on HOSS 2.0 |
| Hydraulic or gas charged | Gas charged |
| Location | Rear |
| Fitment type | Direct fit |
| Vehicle | Ford Bronco, 2021 to 2026, HOSS 2.0 |
Vehicle fitment
The shock fits the 2021 to 2026 Ford Bronco in the Badlands, Base, Big Bend, Black Diamond, First Edition, Outer Banks and Wildtrak trims. The Bronco Raptor is not compatible.
ICON states HOSS 2.0 is standard on most Bronco sub-models with the Sasquatch package, and the 2022 Wildtrak can carry the optional HOSS 3.0 package instead. The Bronco Raptor is not compatible. Confirm your vehicle’s year, model and trim before ordering.
Wheel and tire notes
Without Sasquatch, ICON recommends 17 by 8.5 inches with a 5.75-inch backspace and 25mm offset. With Sasquatch, it recommends 17 by 8.5 inches with a 4.75-inch backspace and 0mm offset. The recommended tire is 35 by 12.50 inches, and 37-inch tire packages may require fender trimming and modifications.
What’s included
The shock is sold individually, so two are needed per vehicle. Check the mounting hardware against your installation before starting.






