Overview
The High Lifter Products Max Clearance front forward control arms in silver, part number HLPMCFFA-RNG9-S, are arched upper and lower control arms for the Polaris Ranger 900 XP and other Ranger models. The arch provides the clearance needed to run tires up to 30 inches.
A Ranger without arm modifications runs tires up to 26 inches, which is small for true mud riding. These arms raise that limit and work with High Lifter’s 2-inch and 4-inch Ranger 900 lift kits. The arms are made in the USA.
Key features
- Arched upper and lower control arms for added front clearance
- Clearance for tires up to 30 inches
- Works with High Lifter 2-inch and 4-inch Ranger 900 lift kits
- Made in the USA
- Silver finish
Matching arms to your tires
Control arm clearance is only one part of running larger tires. The tire has to clear the fender, the inner fender liner, the steering components and the bumper at full lock and full suspension travel. Rub marks on a fender or a bumper are usually the first sign that the tire is too large for the current setup.
Steering geometry also changes when tire size and arm length change. Larger tires can make steering heavier and increase the load on ball joints and tie rods. Check toe and caster after installation, and inspect the steering stop and CV boot area after the first few drives on rough ground.
- Check tire clearance at full lock
- Look for rub marks after the first ride
- Inspect ball joints and tie rod ends
- Keep spare bushings on hand for the lower arm
Specifications
| Brand | High Lifter Products |
|---|---|
| Part number | HLPMCFFA-RNG9-S |
| Finish | Silver |
| Arm type | Upper and lower, arched, front forward |
| Tire clearance | Up to 30 inches |
| Largest tire without arm modifications | 26 inches |
| Compatible lift kits | High Lifter 2-inch and 4-inch Ranger 900 kits |
| Country of manufacture | USA |
Vehicle fitment
It fits Polaris Ranger models from 2013 to 2018, including the Ranger 570, 6×6 800, 900 and 1000 models and their Crew, Diesel and XP versions. Confirm fit for your vehicle’s year, model and trim before ordering.
Front Outlaw DHT axles and certain bumpers need the extra steps described below. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
If you run Front Outlaw DHT axles with this kit, add the Polaris Steering Stop Kit (part RANGER-SSK) to avoid clearance problems at the CV boot.
Check the ball joints, bearings and bushings for wear before installation, and replace any that are worn. High Lifter lists bearing part BJP-3 for the ball joints and bushing part WBK-25-1628 for the lower control arm, and part number BK-50-1076 is also referenced.
If you plan to run these arms with bumper BUMPER-RNG9 or a similar bumper, the bumper must be modified, cut or trimmed to clear tires 28 inches or taller.
What’s included
The silver front forward control arms.
Not included: the steering stop kit, bearings and bushings covered in the installation steps, which are sold as separate parts.









