Overview
The 370-90742 is a camber adjustable front lower control arm built as a direct OE replacement. It fits the 2017–2021 Can-Am Maverick X3 and Maverick X3 Max.
The arm uses a heavy-duty, high-clearance design that improves ground clearance while keeping the arm strong. Factory lower arms are a known weak point on the X3, so this arm is a common early suspension upgrade.
Most adjustable arms use a threaded rod end, which does not allow fine camber adjustment. Cognito uses a bolt-on uniball rod end that can be shimmed for fine camber tuning, with shims supplied in the package.
Key features
- Direct OE replacement design
- Heavy-duty, high-clearance arm
- Bolt-on uniball rod end
- Shim-adjustable for fine camber tuning
- Supplied shims for camber changes
Camber and tire wear
Camber changes affect how the tires contact the ground. Negative camber can wear the inner edge of a tire, while positive camber tends to wear the outer edge. Set camber with the vehicle at its normal ride height and with the tires at the pressure you run, since both change the reading.
Adjusting camber with shims is a slow process. Make one change, recheck the angle, and then decide whether another is needed. Keep a record of each shim count so you can return to a known setting if the handling feels wrong. Re-check toe after any camber change, because the two settings are linked on most setups.
Lower arms work with the ball joints, tie rods and bushings. If the joints show play or the bushings are cracked, camber readings will drift, and adding shims will not correct that. Inspect those parts before aligning the vehicle, and replace any that are worn.
Specifications
| Brand | Cognito Motorsports |
|---|---|
| Part number | COG370-90742 |
| Position | Front lower control arm |
| Adjustment | Shim-adjustable uniball rod end |
| Design | Direct OE replacement |
| Model years in fitment list | 2017–2021 |
Vehicle fitment
It fits the 2017–2021 Can-Am Maverick X3 and the 2017–2021 Maverick X3 Max. Other Maverick models are not covered. Confirm your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Camber is changed by unbolting the rod end from the control arm, then adding or removing the supplied shims until the camber angle is right. Reinstall the rod end and check the alignment after any change.
What’s included
The supplied shims are included. Check the package contents against your installation before starting.











