Overview
The Hedman oxygen sensor header reducer, part number HED21142, steps a 3 in., 3-bolt collector down to a 2.5 in. exhaust. It is an oxygen sensor reducer and is sold individually.
Reducers like this let a header collector connect to smaller exhaust piping. It is universal fit and names no specific vehicle, year or engine.
Key features
- Connects a 3 in. 3-bolt collector to a 2.5 in. exhaust
- Oxygen sensor reducer design
- Sold individually
- Universal fit
Collector and reducer matching
A reducer works as a transition between two different diameters, so the flow path and the joint both matter. Going from a larger collector to a smaller pipe changes gas velocity at the step, and a clean internal transition helps keep backpressure from building. Check that the reducer’s inlet bolt pattern lines up with the collector flange before committing to a cut.
Sensor reducers often sit close to the engine and under heat shields, so clearance matters. Leave room for the sensor and its wiring, and keep the wire away from hot surfaces. Compare the reducer with the rest of the header and downpipe layout to confirm it will not pinch the pipe or bind on the chassis. Recheck the joint after the first heat cycles. Keep a record of the measurements you take so the next part you buy matches the same layout.
Specifications
| Brand | Hedman |
|---|---|
| Part number | HED21142 |
| Collector inlet | 3 in., 3-bolt |
| Exhaust outlet | 2.5 in. |
| Sold as | Individually |
Vehicle fitment
It is universal fit, with no vehicle, year or engine named. Measure your collector flange and exhaust diameter so the 3 in. and 2.5 in. sizes match your system before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Confirm the mounting method for your system before cutting or welding any exhaust pipe.
What’s included
One oxygen sensor header reducer, sold individually. Confirm whether gaskets, clamps and other hardware are needed for your installation before starting.









