Overview
The G2 Axle and Gear 65-2013 is an open differential carrier for Ford 8.8 inch axles, supplied as an empty case that takes your own ring gear and pinion. It is a direct replacement for the factory differential, with the case break set to suit the gear ratio you run.
Builders and repair shops choose a bare carrier like this when a worn or damaged original needs swapping and a complete assembly is more than the job calls for. The manufacturer also names Mazda 8.8 inch as an axle type, so measure the housing before you commit.
Key features
- Direct replacement for the factory open differential case
- Empty case, ready for a ring gear and pinion set matched to your ratio
- Case break offered to suit the chosen gear ratio
- Front and rear axle location listed by the manufacturer
- Economical route for repairs compared with a full carrier assembly
Bare carrier vs. complete assembly
A bare carrier is the part to pick when the case itself is worn or damaged but the ring gear and pinion are still usable, or when you plan to match a new gear set to your ratio. Shops often inspect the rest of the axle first, checking the axle tubes, bearing seats and shaft ends, because a new case cannot correct a bent housing or worn bores.
Gear mesh and bearing preload are set when the case goes back in, so plan time for measuring and shimming rather than a quick swap. Keep the old gears only if they are in good shape and match them to the new case, or budget for a new set at the same time.
- Measure the housing before ordering
- Inspect bearing bores and seats
- Budget for ring and pinion, bearings and seals
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 65-2013 |
| UPC | 631410096347 |
| Axle type | Ford 8.8 inch; Mazda 8.8 inch |
| Popular axle manufacturer | Ford |
| Axle location | Rear; front |
| Differential type | Open differential case only |
| Axle spline | Empty case |
Vehicle fitment
Vehicle years and chassis codes do not set fit for this carrier. It is a universal fit part for Ford 8.8 inch or Mazda 8.8 inch axles, so measure the housing rather than relying on a model name.
Other axle families, including GM 10 bolt housings, are different parts and are not covered by these axle types. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Fitting a bare case means opening the axle housing, setting ring gear backlash and checking bearing preload, work most owners hand to a shop experienced with carrier setup. Support the vehicle on stands before working underneath it.
What’s included
The empty open differential case body only.
Not included: the ring and pinion, bearings and axle shafts must be sourced separately.







