Overview
The G2 Axle and Gear 85-2034-3 is a full spool for Dana 60 rear axles with 35 splines and 4.10 Down gearing. A full spool locks the left and right axle shafts together, so both wheels keep receiving power when one wheel lifts off the ground. It is CNC machined from 4130 billet steel and is a light weight part for demanding use.
Key features
- CNC machined from 4130 billet steel
- Full spool design sends power to both wheels even when one is in the air
- Built for 35 spline axle shafts
- Fits Dana 60 rear axle housings
- Light weight construction
- Built for 4.10 Down gearing
Before you install
A spool replaces the open differential, so both wheels turn together on loose ground or when one wheel loses traction. The trade-off is that the axle always pushes both tires the same way, which can cause tire scrub in tight turns and a clunk on pavement.
Before buying, check the ring gear and pinion, bearings and carrier condition, since a spool adds load to those parts. Worn bearings and a damaged pinion are common reasons to rebuild the carrier at the same time. Look for chipped gear teeth, noise under throttle and fluid that smells burnt, all of which suggest the old gears need attention first. Keeping the gear set quiet and well shimmed makes the difference between a spool that is pleasant to drive and one that is loud at highway speed.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 85-2034-3 |
| UPC | 631410103441 |
| Differential type | Spool |
| Material | 4130 billet steel, CNC machined |
| Axle type | Dana 60 |
| Axle location | Rear |
| Axle spline | 35 splines |
| Gear ratio | 4.10 Down |
| Popular axle manufacturer | Dana |
| Fitment listed | Universal fit |
Vehicle fitment
It is a universal fit for Dana 60 rear axles with 35 spline shafts, so the axle housing and spline count decide fit. It is a rear axle part, not a front axle part.
The 30 spline version of this spool is a separate part number, 85-2034-3-30, and will not match 35 spline shafts. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A spool replaces the open differential inside the carrier, so installation usually means removing the carrier and setting the ring and pinion pattern. Professional installation is typical for this type of part, and the 4.10 ratio should match the ring and pinion already in the axle.
What’s included
Only the spool itself is included.
Not included: Bearings, ring gear and installation hardware are not included.








