Overview
The G2 Axle and Gear Ford 8.8 inch internal kit is a replacement gear set for a Ford 8.8 inch rear axle with 31 splines, built for open differential carriers. It is meant for swapping out worn or damaged internal gears in place of a full carrier.
G2 adds the note 87 and up to the 31 spline version, but no vehicle year, make or model is named.
Key features
- 31 spline axle
- Built for open differential carriers
- Set includes spider gears, side gears, thrust washers, a cross shaft and a retaining pin
- Ford 8.8 inch rear axle type
Rebuilding an open 8.8 carrier
An open differential carrier splits torque between the wheels, so the spider and side gears carry load mainly when one wheel slips. Because they share that load in turns, the kit’s gears and thrust washers can wear together. When the set is replaced, the carrier is often checked for case damage, bearing condition and ring gear wear at the same time.
Gear kits for the 8.8 inch Ford axle work best when the carrier is reassembled with care. Thrust washer clearance and gear backlash both affect how smoothly the set runs. A shop that sets mesh and preload should handle the assembly, and the new gears should be run in gently before heavy use.
- Inspect the ring gear and pinion for wear
- Replace the carrier bearings if they show pitting
- Check backlash and contact pattern before reinstalling
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| UPC | 631410093247 |
| Component | Internal gear kit |
| Case type | Open only |
| Axle type | Ford 8.8 Inches |
| Axle location | Rear |
| Axle spline | 31 splines |
| Spline note | 87 and up |
Vehicle fitment
The kit is matched by axle type: the Ford 8.8 inch rear axle with 31 splines. Compare your axle with that type before ordering, since no year range, make or model applies.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A shop that sets gear mesh and carrier preload should assemble this kit, and the new gears need a break-in run once back in service.
What’s included
The set includes side gears, spider gears, thrust washers, a cross shaft and a retaining pin, with no other pieces named.





