Overview
The G2 Dana 44 Chromalloy inner axle shaft, part G/297-2033-004, is a passenger-side front shaft for the Dana 44 axle, with 30 splines. It is made for the 1971–1977 Ford Bronco and the 1975–1977 Ford Bronco Sport.
G2 forges the shaft from high-grade alloy steel and heat treats it to exceed OEM specifications. The brand describes rolled splines and better materials as the features that let owners run larger tires without the shaft failing under high torque.
Key features
- Forged from high-grade alloy steel and heat treated to exceed OEM specifications
- 30-spline shaft for the Dana 44 front axle
- Accepts the 5-760X U-joint
- Machined to accept full circle clips
- Passenger-side inner position
- Rolled splines for added strength under load.
Before fitting a Bronco axle shaft
On a Dana 44 front, the inner shaft carries drive from the differential side gear out to the hub, so it is loaded during every turn and every change in throttle. The retaining method matters as much as the shaft itself. Full circle clips hold the shaft in the axle tube, and the groove and clip must match before the shaft is pushed home.
Inspect the old shaft for twisted or worn splines, cracks near the spline root and wear at the U-joint end before choosing a replacement. Replacing the axle seal and checking the carrier bearings are common steps at the same time, since the shaft must be removed to reach them. Clean the axle tube and check the side gear splines for matching wear.
- Check the spline count against the axle
- Confirm the clip type before installation
- Inspect the axle seal while the shaft is out
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | G/297-2033-004 |
| Axle type | Dana 44 |
| Axle location | Front |
| Shaft position | Passenger side, inner |
| Spline count | 30 splines |
| U-joint | 5-760X |
| Clip type | Full circle clips (machined to accept) |
| Material | High-grade alloy steel, heat treated |
Vehicle fitment
Fits the 1971–1977 Ford Bronco and the 1975–1977 Ford Bronco Sport. Make sure the year, model and trim match your vehicle first.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The shaft is machined for full circle clips, so the retaining hardware has to match that type. Check the spline count and U-joint size against the axle you are replacing before fitting the new shaft.







