Overview
The 68003534AA is a rear passenger side axle shaft for the Dana 35, with 27 splines. It fits 2007–2018 Jeep Wrangler (JK) 2-door and 4-door models.
The position is rear right with passenger side location. The title’s wording reads passenger driver side, but the bullets confirm the passenger side.
Key features
- Rear passenger side shaft
- Dana 35 axle type
- 27 splines
Before you install
Axle shafts carry torque from the differential to the wheel hub, so a shaft that is worn or bent can cause vibration and clicking under load. On a Dana 35 rear axle, the shaft connects to the axle joint at one end and the hub at the other, so the splines at each end must mesh cleanly with the mating parts.
Before removing the old shaft, look at the axle seal and inner joint for grease leaks. Replacing the seal and bearing at the same time is common when the axle is already open, since that work is easiest with the hub disassembled. Clean the splines and check the retaining hardware before the new shaft goes in.
- Inspect the axle seal and boot for grease
- Clean the spline surfaces before installing
- Replace worn hub hardware while the axle is open
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 68003534AA |
| Axle maker | Dana |
| Axle location | Rear |
| Axle shaft location | Passenger side |
| Position | Rear right |
| Axle type | Dana 35 |
| Axle spline | 27 splines |
Vehicle fitment
It fits 2007–2018 Jeep Wrangler (JK) 2-door and 4-door models in the 70th Anniversary, 75th Anniversary, Rubicon, Sahara, Sport, Sport S and X trims, plus their Unlimited versions.
It is a direct fit for the 2007–2018 Jeep Wrangler JK in the trims shown. Measure the shaft being replaced and compare its 27 splines and Dana 35 type with this passenger side unit before fitting.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
One rear passenger side axle shaft.









