Overview
The G2 Axle and Gear 65-2028 is an open differential carrier for the Chrysler 9.25 inch rear axle. It is an open differential case only and replaces the factory differential.
G2 presents it as a repair part and an economical way to get the proper case break for your gear ratio. Its empty spline means the ring gear and pinion are added separately, so the gear set must be chosen to suit the case.
Key features
- Direct replacement for the factory Chrysler 9.25 inch differential
- Open differential case only, listed with an empty spline
- Economical way to get the proper case break for your gear ratio
- Rear axle location
Matching the ring gear
The ring gear bolts to the carrier flange and must seat flat against the case, so the carrier and ring gear are a matched pair. Ring gears are sold in sets with a matching pinion, and the gear ratio decides which set fits the case you have. Reusing an old ring gear on a new carrier is rarely worthwhile, since bolt holes and the mounting face wear over time.
Consider the axle as a whole when you choose a carrier. Axle shafts, bearings and the pinion seal often need attention at the same time the carrier is replaced. Keep track of the gear ratio and fluid type from the old unit so the rebuild matches the vehicle’s original setup.
- Replace the ring gear and pinion as a matched set
- Check the mounting face and bolt holes for wear
- Inspect axle bearings and the pinion seal during the rebuild
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 65-2028 |
| UPC | 631410096446 |
| Popular axle manufacturer | Chrysler |
| Axle location | Rear |
| Axle type | Chrysler 9.25 Inches |
| Axle spline | Empty case |
| Differential type | Open differential case only |
Vehicle fitment
Confirm fit by matching your housing to the Chrysler 9.25 inch axle type in the rear location before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Ring gear and pinion installation sets the backlash and bearing preload, which is specialist work for a rebuilder with the right tools.
What’s included
One open differential case with an empty axle spline.
Not included: ring gear and pinion set, since the case is empty.







