Overview
The FUEL Off-Road D718 Heater 20×10 with a 6 on 5.5 bolt pattern is a Matte Black split spoke aluminum wheel. Its part number is MHTD71820008447.
The center bore is 106, the backspacing 6.2 and the offset -18, with a width of 10 inches. No vehicles are named for this wheel, so the bolt pattern and bore are the first measurements to confirm.
Key features
- 6 on 5.5 bolt pattern
- 106 center bore
- 20-inch diameter, 10-inch width
- Split spoke style in Matte Black
- Offset -18 and backspacing 6.2
Hub bore and centering
Center bore is the hole in the middle of the wheel that fits over the hub. When the bore matches the hub closely, the wheel centers itself and the lug nuts carry only clamping load. A bore that is too small will not seat at all, while a bore that is too large relies on the lug nuts to center the wheel, which can cause vibration and stud wear over time. Hub-centric rings are sometimes used to close the gap, and they should be sized and seated with care.
A six lug pattern is often paired with different hub designs, so confirm the pattern and then check the hub face for raised rings or dirt that could keep the wheel from sitting flat. Clean the hub face and wheel contact surfaces before mounting, and tighten lug nuts in a star pattern. Recheck torque after the first short drive, since new wheels settle slightly against the hub.
- Clean the hub face before mounting
- Tighten lugs in a star pattern
- Recheck torque after the first drive
- Inspect studs for damage at each tire change
Specifications
| Brand | FUEL Off-Road |
|---|---|
| Part number | MHTD71820008447 |
| Series | D718 Heater |
| Diameter | 20 inches |
| Width | 10 inches |
| Bolt pattern | 6 on 5.5 |
| Center bore | 106 |
| Offset | -18 |
| Backspacing | 6.2 |
| Style | Split Spoke |
| Finish | Matte Black |
| Construction | Aluminum |
Vehicle fitment
The 6 on 5.5 pattern and 106 center bore must match a specific hub, so fit depends on those figures together with the -18 offset.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Verify the 6 on 5.5 pattern and 106 center bore against the hub before mounting. A mismatch means the wheel will not seat properly, and the -18 offset also needs clearance checks.
What’s included
Only the single wheel is described.
Not included: Plan to source tires and lug hardware on your own.

















