Overview
The Firestik TS105ADT is a heavy-duty antenna stud mount, part number TS105ADT, with an SO-239 type plug connection that screws on. It is made from chrome plated machined brass and stainless steel and is made for CB mounts and cables.
The plug fits a 1/2 inch hole, and the center shaft uses a standard 3/8 x 24 thread. Those two sizes decide whether the mount works with your mounting point and antenna.
Key features
- SO-239 type plug mount with a screw-on connection
- Chrome plated machined brass and stainless steel construction
- Standard 3/8 x 24 thread type center shaft
- Plug fits a 1/2 inch hole
Choosing and fitting a stud mount
A stud mount clamps to the vehicle through a drilled hole, so the hole size and the mount’s base decide how solid the setup will be. Before you tighten anything, check that the body metal around the hole is clean and free of paint build-up, since a clean contact area helps the mount hold and keeps the antenna grounded. Stud mounts are often replaced when the threads wear or the plug loosens, so inspect them each time you remove the antenna.
Antenna loads at speed put steady force on the stud, and a loose mount can rattle, cause noise, or let water into the hole. Retighten the nut after the first few drives and again after rough roads. Corrosion on brass and stainless parts shows up as dull spots or stiffness when threading. Clean them and replace any damaged part before it fails on the trail.
- Check the nut and plug for looseness after the first drives
- Clean the mounting surface before installing
- Replace the mount if threads or the plug show damage
Specifications
| Brand | Firestik |
|---|---|
| Part number | TS105ADT |
| UPC | 92533023601 |
| Mount type | Heavy-duty antenna stud mount |
| Connection | SO-239 type plug mount, screw-on |
| Material | Chrome plated machined brass and stainless steel |
| Center shaft | Standard 3/8 x 24 thread type |
| Hole size | Plug fits 1/2 inch hole |
| Fitment listed | Universal Fit |
Vehicle fitment
It is a universal fit mount, not tied to a specific make, model or year. The plug size and thread must match your antenna and mounting hole.
Confirm fit for your vehicle’s year, model and trim before ordering. Check that the thread matches your antenna and that the hole matches your mounting point.
Installation notes
Measure the mounting hole first, since the plug is sized for a 1/2 inch hole. Match the center shaft to the 3/8 x 24 thread of your antenna before tightening.
What’s included
Check the package contents against your installation before starting.
Not included: An antenna, since this is a stud mount that holds one.
















