Overview
The Fab Fours DR13-D2951-1 is a Vengeance Series front bumper without a guard for 2013 to 2018 Ram 1500 pickups, a lightweight steel sensor bumper finished in two-stage black powder coat.
The center mount is sized for a Rigid Industries 20-inch LED light bar, and the side positions take two 2×2 Dually lights. Neither light type comes with the bumper. A lower cutout passes air to the intercooler, and the bumper is a high and tight fit with an aggressive look. Sensors set up on lifted trucks may read the ground on a stock-height truck because of the bumper’s angles.
Key features
- Lightweight design: 65 lb with no guard, 75 lb with the pre-runner guard
- Center mount sized for a Rigid Industries 20-inch LED light bar
- Side mounts for two 2×2 Dually lights
- Lower cutout for airflow to intercoolers
- Complete bolt-on bumper; brackets tie directly to the frame
- Two-stage black powder coat
- 11 ga. U.S. steel construction
- Made in the USA
Sensors and ride height
Parking sensors are calibrated around the bumper face and the distance from the ground, so changes to ride height can alter what they detect. A stock-height truck places the sensor face closer to the ground at the bumper’s low edge, which can cause false readings in grass, gravel or on uneven pavement.
Sensor ground echoes are common on front bumpers with a sharp lower profile. Test the system at low speed in an open area, then watch how it reacts to curbs and tall grass. If false alerts persist, check the sensor settings in the vehicle and confirm the ride height. Clean the sensor faces regularly, since a film of mud affects readings.
- Test sensors at low speed after installation
- Clean sensor faces after muddy drives
- Note any changes in false alerts over time
- Recheck readings after changing tire size
Specifications
| Brand | Fab Fours |
|---|---|
| Part number | DR13-D2951-1 |
| UPC | 5810110833 |
| Type | Vengeance front bumper, no guard |
| Position | Front |
| Width | Full |
| Material | Steel, 11 ga. U.S. steel |
| Finish | Two-stage black powder coat |
| Fit type | Direct fit |
| Light mounts | Included |
| Winch mount | Not included |
| D-ring mounts | Not included |
| Sensors | Sensor bumper; see fitment notes |
Vehicle fitment
It is a direct fit for the 2013 to 2018 Ram 1500.
The 2009 to 2012 Ram 1500 and the Ram 2500 and 3500 are not on the list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This bumper bolts on with supplied brackets that attach to the frame. Wire any LED bar or Dually lights through a fused relay, and check how the parking sensors behave on a stock-height truck.
What’s included
- Vengeance front bumper without guard, in black powder coat
- Frame-mounting brackets
Not included: The 20-inch LED light bar, the Dually lights, a winch mount and D-ring mounts.
















