Overview
The Fab Fours premium rear sensor bumper, part number CS14-W3151-1, is a black rear replacement bumper for the Chevy and GMC 1/2 ton. It integrates the existing receiver hitch and adds steps on either side of the tailgate, along with D-ring recovery points.
The D-ring mount is included with this bumper. The receiver hitch and wiring locations are retained. The bumper is built from formed steel. Confirm the year and cab of your truck before ordering.
Key features
- Black finish
- Integrated steps on either side of the tailgate
- Formed steel construction
- Retains the OEM receiver hitch and wiring locations
- 3/4-inch D-ring recovery points
Before you install
A rear bumper carries more than its own weight. It takes the load of recovery points, steps and any tire carrier, and it sits on the same frame area that the receiver hitch uses. Before fitting one, look at the frame rails and crossmember where the bolts pass through, and make sure they are sound and free of rust. Tighten all hardware once the bumper is in place, then re-check the bolts after the first few trail runs, since steel bumpers can shift slightly under repeated impacts.
If you plan to carry a spare, decide on the tire carrier before ordering. Carriers add weight behind the axle and change how the hitch loads the frame, so the bumper and carrier should be chosen together. Clear the steps and D-rings for approach angle and check that the tailgate still opens fully. Touch-up paint on bare edges helps slow corrosion over time, and it is far easier to do before rust begins under the coating.
Specifications
| Brand | Fab Fours |
|---|---|
| Part number | CS14-W3151-1 |
| UPC | 5810110116 |
| Finish | Black |
| Construction | Formed steel |
| Recovery points | 3/4-inch D-rings, included |
| Truck | Chevy/GMC 1/2 ton |
Vehicle fitment
It is designed for Chevy/GMC 1/2 ton trucks. Confirm the year and cab of your truck before ordering, and check the bumper against your tire carrier and hitch needs.
Installation notes
The bumper reuses the existing receiver hitch and wiring locations. Check the bolt-on steps against your truck’s frame mounting points before installing.
What’s included
Included: the rear bumper with its D-ring mount.
Not included: a tire carrier and a receiver hitch.












