Overview
The Crown Automotive 3507678 is a differential crush sleeve for Chrysler vehicles with a 9.25 in. rear axle. A crush sleeve sets the pinion bearing preload during assembly, so the sleeve has to match the axle it is used in. It is a direct fit in the rear position.
It fits several Dodge trucks and SUVs, including the Dakota, the Durango and the Ram 1500, 2500 and 3500 in the years shown below.
Key features
- Differential crush sleeve for a 9.25 in. rear axle
- Rear position, direct fit
- Fits several Dodge and Ram truck and SUV years
- Part number 3507678
Setting pinion preload
A crush sleeve is a one-use spacer. As the pinion nut is tightened, the sleeve deforms slightly and holds the pinion bearings at the preload set during assembly. Because the sleeve gives way under load, it is normally replaced every time the pinion is removed, and the preload is then set again from the start.
Preload is checked by measuring the force needed to keep the pinion turning once the nut is set. Tighten in small steps, check the rotating torque often, and avoid overtightening, since that squeezes the bearings and shortens their life. Inspect the pinion yoke, seal surface and bearing races while the axle is apart.
- Use a new sleeve each time the pinion is removed
- Check rotating torque in small steps
- Inspect bearing races for pitting
- Confirm the 9.25 in. axle size before assembly
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 3507678 |
| UPC | 848399002614 |
| Rear axle | 9.25 in. Chrysler rear axle |
| Position | Rear |
| Fitment | Direct fit |
Vehicle fitment
It fits the 1998-2010 Dodge Dakota, the 1998-2009 Dodge Durango, the 1994-2008 Dodge Ram 1500 and 2500, the 1994-2002 Dodge Ram 3500, the 2011-2014 Ram 1500, 2500 and 3500, and the 2011 Ram Dakota.
The fit covers the Dakota, Durango and Ram years shown, and 2009-2010 Ram trucks are outside it. Check the rear axle is 9.25 in. before ordering. Confirm fit for your vehicle’s year, model and trim.
Installation notes
The crush sleeve has to be set to the correct preload when the pinion is installed, so the sleeve is matched to the rear axle before assembly. Confirm the 9.25 in. size on your axle before fitting.
What’s included
One differential crush sleeve.









