Overview
The Dee-Zee DZ4451JL is a pair of A-pillar accessory brackets for mounting cube lights or a camera on a Jeep Wrangler JL or Gladiator. The brackets require a hex series A-pillar for installation.
Dee-Zee designs these brackets for Jeep Wrangler JL models. The manufacturer fitment list covers the 2018-2026 Jeep Wrangler (JL) 2-door and 4-door models and the 2020-2026 Jeep Gladiator.
Key features
- Pair of A-pillar accessory brackets
- Heavy duty steel construction
- Texture black powder coat finish
- No drill installation
- Installation hardware included
- Made in USA with a 3 year warranty
Wiring and power for cube lights
Cube lights on an A-pillar bracket are most useful for lighting the trail edge and the area ahead of a stopped vehicle. Because the brackets sit high and near the windshield, the light’s position and aim matter as much as its brightness. Set the aim on level ground, then check it again after rough trail runs, when vibration can shift the housing.
Plan the wire route before final assembly. Run the harness along existing pillar and roof trim, keep it clear of door hinges and moving parts, and use a fused relay so the switch carries only a small load. Heavier lights draw more current, so match the wire to the light’s draw rather than the bracket’s size.
Keep the bracket area clean. Grit trapped under the mounts can wear the textured powder coat, so wipe the surface before tightening the hardware.
- Aim lights on level ground
- Use a fused relay for any powered light
- Route wiring away from door hinges
- Recheck aim after rough trail use
Specifications
| Brand | Dee-Zee |
|---|---|
| Part number | DEEDZ4451JL |
| Material | Heavy duty steel |
| Finish | Texture black powder coat |
| Sold as | Pair |
| Warranty | 3 year |
Vehicle fitment
The brackets fit 2018-2026 Jeep Wrangler (JL) and 2020-2026 Jeep Gladiator models.
Jeep Wrangler models before 2018, including the JK, are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The brackets require a hex series A-pillar on the vehicle before they can be installed. Installation hardware is included and no drilling is needed.
What’s included
A pair of A-pillar accessory brackets and installation hardware.
Not included: Cube lights, which you choose separately.









