Overview
The Fishbone Offroad FB21058 is an A-pillar light bar bracket for a 50-52 inch LED light bar. It fits the 2019-2026 Jeep Wrangler JL and the 2020-2026 Jeep Gladiator.
The bracket mounts without drilling and accepts any 50-52 inch light bar. It includes a foam backing that protects the paint on the vehicle where the bracket sits.
Key features
- A-pillar mount position
- Accepts any 50-52 inch light bar
- Mounts without drilling
- Foam backing included to protect paint
- Black color
Protecting paint under light bars
Brackets that sit on the A-pillar rely on the foam backing and clean mounting surfaces to avoid marks on paint. Clean the mounting spot and remove grit before placing the foam, since trapped debris can scratch the finish under pressure. Keep the bracket level and check that the bar’s weight is spread across the mounting points rather than concentrated on one side.
Over time, foam can compress or pick up dirt, so inspect it periodically and replace it if it hardens or cracks. Light bars on A-pillar brackets also benefit from a check of the wiring route and bracket bolts after rough trails. Tighten fasteners gradually and evenly, and avoid overtightening, which can dent thin body panels.
- Clean the surface before placing the foam
- Replace foam that has hardened or cracked
- Check bolts after rough trails
Specifications
| Brand | Fishbone Offroad |
|---|---|
| Part number | FISFB21058 |
| Mount location | A-Pillar |
| Light bar width | 50-52 inch |
| Color | Black |
| Installation | No drilling |
| Included | Foam backing |
Vehicle fitment
It fits 2020-2026 Gladiator in Launch Edition, Overland, Rubicon, Sport and Sport S trims, and 2019-2026 Wrangler JL, with Rubicon, Sport and Sport S two-door versions and Unlimited Rubicon, Sahara, Sport and Sport S four-door versions.
The 2018 Wrangler JL, Unlimited Moab trims, two-door Sahara trims and Wrangler JK models are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The foam backing should stay between the bracket and the paint during mounting. Check fit against the A-pillar before final tightening.
What’s included
The light bar bracket with foam backing.
Not included: no light bar is supplied with the bracket.

















