Overview
The Daystar KF09102BK is a ComfortRide rear leveling kit, a coil spring spacer kit with a 1 inch lift, for the 1997-2002 Ford Expedition in Eddie Bauer and XLT trims. Coil spring spacers sit with the rear coil springs to raise the ride height at the back of the vehicle.
The ComfortRide suspension kits are designed to raise vehicle height, improve performance, add ground clearance, allow larger tires and reuse most stock components. This kit offers a lift height range of 0 to 2.25 inches, comes in black, and does not include shocks. Confirm that the stock shocks remain suitable at the raised ride height before installing.
Key features
- Coil spring spacer kit
- ComfortRide suspension line
- Rear position
- 1 inch leveling lift, with a lift height range of 0 to 2.25 inches
- Black finish
- It reuses most of the stock components.
- Direct fit
- Does not include shocks
Ride height and the rear end
Raising the rear with coil spacers changes the geometry of the whole rear suspension. Driveshaft angle, brake line length and the position of the bump stops all shift, so the effects are worth checking rather than assuming. Shock length and valving also matter, because a shock that was adequate at stock height can run near the end of its travel at a higher ride height.
Make the installation a full check. Look at the brake lines and driveshaft for clearance through full travel, and check the tires against the fender at full compression. An alignment check after a ride-height change keeps tire wear even. Keep the load in the rear in mind, since heavy loads can reduce the effect of the spacers.
- Check driveshaft angle and vibration
- Confirm brake lines have clearance through travel
- Review shock length and condition
- Recheck alignment after the change
Specifications
| Brand | Daystar |
|---|---|
| Part number | KF09102BK, also catalogued as DAYKF09102BK |
| UPC | 814423010542 |
| Product type | Coil spring spacer leveling kit |
| Series | ComfortRide |
| Position | Rear |
| Lift | 1 inch |
| Lift height range | 0 to 2.25 inches |
| Color | Black |
| Shocks | Not included |
| Fit type | Direct fit |
Vehicle fitment
The manufacturer fitment list for the Daystar KF09102BK includes:
- 1997–2002 Ford Expedition (Eddie Bauer, XLT)
The kit fits the 1997-2002 Ford Expedition in Eddie Bauer and XLT trims only. Other Expedition years and other Ford vehicles are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
These spacers sit in the rear coil springs, so the rear has to be unloaded safely. Use rated stands on a flat surface, follow the installation directions and torque all fasteners to specification. A shop can handle it if you prefer.
Check the bolts again after a short drive and make sure the brake lines and driveshaft have room through full travel. An alignment check is worthwhile after a ride-height change, and your local equipment and height rules still apply.
What’s included
- Daystar ComfortRide rear coil spring spacer kit
Not included: shocks, which are not included.









