Overview
The Currie CE-9110 is a 2-1/2 inch Johnny Joint rod end that must be welded on, made for fabricators and suspension builders. Unlike the CE-9110P, this version comes with its greasable bolt, nut and washers, and it is greased internally through that supplied bolt.
The movement is rated at 30 degrees in any direction, compared with 22 degrees for a standard heim joint. The bushings are urethane, the center ball is heat-treated steel, and the retaining washers are heat-treated steel as well. The outer shell is .180 inch DOM tubing, and the joint is fully rebuildable.
Key features
- Internally greased through a supplied greasable bolt
- Greasable 9/16 inch bolt with nut and washers included
- Urethane bushings around the inner ball
- Center ball cross-drilled for thru-bolt lubrication
- Must be welded on
- Fully rebuildable
Lubrication and rebuilds
A joint that is greased internally through a bolt depends on that bolt staying in service, so the greasing route and the hardware both matter. Keep the greasable bolt, nut and washers clean and inspect them when the arm is serviced. Pumping grease through the bolt pushes out grit and water that would otherwise wear the bushing and ball.
Rebuilding a joint is a practical option when wear builds up, because the internals can be replaced without cutting the joint out of the arm. Look for play, rough movement, and grease that does not come through, since these point to worn bushings or a tired ball. If the outer shell is damaged, the joint should be replaced rather than rebuilt.
Specifications
| Brand | Currie |
|---|---|
| Part number | CE-9110 |
| UPC | 51840700001 |
| Mounting type | Weld-on |
| Outside diameter | 2-1/2 inch |
| Mounting width | 2.625 inch |
| Thru-bolt hole | 9/16 inch |
| Lubrication | Internal, through supplied greasable bolt |
| Included hardware | 9/16 inch greasable bolt, nut and washers |
| Bushings | Urethane |
| Outer shell | .180 inch DOM tubing |
| Center ball | Heat-treated steel |
Vehicle fitment
It is a universal part for custom arms and fabricated suspension, so there is no single vehicle to match.
Check the 2.625 inch mounting width and 9/16 inch bolt hole against your bracket before welding. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This joint must be welded on, so it is not a bolt-on part. Welding it into a bracket or arm requires welding equipment. Fit the supplied 9/16 inch greasable bolt, nut and washers through the joint once it is in place.
What’s included
A Johnny Joint rod end with a 9/16 inch greasable bolt, nut and washers.
Not included: the bracket or arm the joint is welded into.









