Overview
The Currie 88-CFDA is a companion flange adapter for 1310 U-joints. It bolts to a 1310 series companion flange style yoke and adapts it to a standard 1310 U-joint, and it is used with Ford 8.8-inch axles.
It is intended for Currie High pinion third members and can be used on yokes supplied in the Currie 231 transfer case tailshaft slip yoke eliminator kits. Confirm fit for your vehicle’s year, model and trim before ordering.
Key features
- Adapts 1310 flange yokes to a standard 1310 U-joint
- Adapts drive shaft to flat flange pinion yokes
- 19 degree joint angle
- Includes metric socket head Allen bolts and lock washers
Matching the flange and yoke
A companion flange adapter only works when the flange and yoke geometry match. Compare the bolt circle, female pilot and flange face dimension with the yoke on the axle before assembly. Mismatched pilots can cause the joint to sit off center, which leads to vibration at speed.
Because the adapter changes how the U-joint seats, check the driveline angles once it is installed. Tighten the flange bolts evenly and re-check them after the first drive. Inspect the U-joint caps and the flange for cracks or galling before reuse, since those parts carry the full driveline load.
- Compare bolt circle and pilot before assembly
- Check driveline angles after installation
- Tighten flange bolts evenly, then re-check
- Inspect U-joint caps for wear before reuse
Specifications
| Brand | Currie |
|---|---|
| Part number | 88-CFDA |
| UPC | 70000327381 |
| Axle | Ford 8.8-inch |
| Bolt circle | 3.50 inch |
| Female pilot | 2 inch |
| Joint angle | 19 degrees |
| Flange face to center line | 1.625 inch |
| Bolts | 12mm |
Vehicle fitment
The adapter is made for Ford 8.8-inch axles and Currie High pinion third members. Fit depends on the axle and the 1310 flange yoke, so confirm the axle type and pinion style against your setup before ordering.
Check the axle type and pinion style against your setup before ordering, and confirm your vehicle’s year, model and trim before ordering.
Installation notes
The adapter bolts to the companion flange with the metric socket head Allen bolts and lock washers included in the kit. Check the 19 degree joint angle against your driveline before final assembly.
What’s included
The adapter, metric socket head Allen bolts and lock washers are included.









