Overview
The Crown Automotive 83502680 is an input shaft inner needle bearing for AX4 and AX5 transmissions. Fitment covers the 1984–1998 Jeep Cherokee (XJ), 1986–1992 Jeep Comanche and 1987–1995 Jeep Wrangler (YJ).
It is sold as one piece. Measure or compare the original bearing before installing this one.
Key features
- Input shaft inner needle bearing for AX4 and AX5 transmissions
- Sold as one piece
- Part number 83502680
- Covers Cherokee XJ, Comanche and Wrangler YJ
Input shaft bearing wear
The inner needle bearing on the input shaft supports the shaft where it meets the transmission, so wear here affects gear alignment and noise. A worn bearing often causes a whine or growl that changes with clutch engagement or road speed. Some owners notice harder shifts as the shaft moves slightly out of position, so note any changes in shifting feel before opening the transmission.
Because this bearing sits inside the case, replacing it is a transmission rebuild task. Inspect the input shaft journal for scoring or heat marks, and check the gears it drives for pitting. Clean the bore carefully and fit the new needle bearing square and fully seated. Reassemble with fresh gaskets and seals, and use the correct fluid for the unit.
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 83502680 |
| Application | AX4 and AX5 transmissions |
| Bearing type | Needle, input shaft inner |
| Quantity | 1 piece |
Vehicle fitment
Fitment covers 1984–1998 Jeep Cherokee (XJ) (Base, Briarwood, Chief, Country, Laredo, Limited, Pioneer, SE, Sport), 1986–1992 Jeep Comanche (Base, Chief, Custom, Eliminator, Laredo, Pioneer, X, XLS) and 1987–1995 Jeep Wrangler (YJ) (Base, Islander, Laredo, Rio Grande, S, SE, Sahara, Sport).
Cherokee XJ years run 1984 to 1998 and Wrangler YJ years stop at 1995. Wrangler TJ, JK and later models are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
An input shaft bearing sits inside the transmission, so replacing it means opening the transmission case. Treat it as a transmission rebuild task rather than a bolt-on fix.
What’s included
One inner needle bearing is included. Check the input shaft, gears and seals separately before reassembly.









